> i think i installed redhat 3.0.3 at the time as well.
> i used an nfs install, i think that is the only think i might
> have done differently.
I can't install anything directly from CD, because my UDB has no CD-Rom
drive. So I used NFS to install too. This is were my first problem began.
The kernel found my network card (tulip), but it assumed, I had installed
a network based on UTP, while my network is based on coax.
So I installed RH 3.0.3 (where my network works fine). I copied all
files via NFS on my UDB SCSI-disk, and then erased all the files on it,
except the /redhat/ directory, where the install stuff was located.
When this didn't work, I plainly installed RH 3.0.3 _again_, and replaced
all the files manually (except for the initscripts). It took me half a
day, but I have an ELF system now :-)
> > It does work? Hmmm...I seem to have lots of problems installing RH 5
> > on my UDB. The installation program always hangs, at some time during
> > the installation of the rpm-packages. Does anyone have the same problem
> > as I have (I installed RH 3.0.3, and replaced _every_ rpm-packet
> > manually).
Regards,
--Maurice