static int sis_get_info(char *, char **, off_t, int);
static int __init sis_get_info(char *, char **, off_t, int);
static int sis_get_info (char *buffer, char **addr, off_t offset, int count)
static int __init sis_get_info (char *buffer, char **addr, off_t offset, int count)
Try inserting "__init" in these two locations......in the sis5513.c file.
On Fri, 24 Mar 2000, Tim N. van der Leeuw wrote:
> Typing
>
> cat /proc/ide/sis
>
> gave me the attached OOPS in 2.3.99pre3-8. I can't remember when it last
> worked. No output was generated.
>
> The following are the boot messages relating to the IDE driver:
>
>
> Uniform Multi-Platform E-IDE driver Revision: 6.30
> ide: Assuming 40MHz system bus speed for PIO modes; override with idebus=xx
> SIS5513: IDE controller on PCI bus 00 dev 09
> SIS5513: not 100% native mode: will probe irqs later
> SiS5597
> ide0: BM-DMA at 0x4000-0x4007, BIOS settings: hda:pio, hdb:pio
> ide1: BM-DMA at 0x4008-0x400f, BIOS settings: hdc:pio, hdd:pio
> hda: SAMSUNG WA32543A, ATA DISK drive
> hdc: WDC AC28400R, ATA DISK drive
> hdd: CD-ROM 36X/AKU, ATAPI CDROM drive
> ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> ide1 at 0x170-0x177,0x376 on irq 15
> hda: SAMSUNG WA32543A, 2442MB w/128kB Cache, CHS=620/128/63, DMA
> hdc: WDC AC28400R, 8063MB w/512kB Cache, CHS=16383/16/63, UDMA(33)
> Partition check:
> hda: hda1 hda2 hda3 hda4 < hda5 hda6 hda7 hda8 hda9 hda10 >
> hdc: hdc1 hdc3 hdc4 < hdc5 hdc6 hdc7 hdc8 >
>
>
> I'm not sure what other info might be relevant; also attached is my
> .config file.
>
>
> On a side-note, I get quite a lot of warnings about hda of the following
> nature:
>
> hda: dma_intr: status=0x58 { DriveReady SeekComplete DataRequest }
>
>
> I've been told these warnings are not serious, but I don't know if
> anyone can advise me on what to do? Disable DMA for the drive?
> Without DMA, my drives seem to be faster anyways... <g>
>
>
> --Tim
>
>
>
Andre Hedrick
The Linux ATA/IDE guy
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Fri Mar 31 2000 - 21:00:12 EST