Hi,
I have three DC21143 ethernet cards and with 2.3.99-pre5 all of them are
detected as eth0:
eth0: DC21143 at 0x1080 (PCI bus 0, device 13), h/w address 00:80:48:cd:77:c2,
and requires IRQ11 (provided by PCI BIOS).
de4x5.c:V0.545 1999/11/28 davies@maniac.ultranet.com
eth0: DC21143 at 0x1400 (PCI bus 0, device 14), h/w address 00:80:48:cd:80:0a,
and requires IRQ10 (provided by PCI BIOS).
de4x5.c:V0.545 1999/11/28 davies@maniac.ultranet.com
eth0: DC21143 at 0x1480 (PCI bus 0, device 15), h/w address 00:80:48:cd:77:17,
and requires IRQ15 (provided by PCI BIOS).
de4x5.c:V0.545 1999/11/28 davies@maniac.ultranet.com
This is independent of the setting of the PIIX support in the kernel (I
have PIIX4). The contents of /proc/pci (which shows only PCI device 13)
and entire dmesg is attached.
I can provide more info if necessary - but please write me directly, I am
not on the list.
Best regards,
Lada
Ladislav Lhotka
Academic Computer Centre, University of South Bohemia
Branisovska 31, C. Budejovice, CZ-370 05 Czech Republic
PCI devices found:
Bus 0, device 0, function 0:
Host bridge: Intel Corporation 440BX/ZX - 82443BX/ZX Host bridge (rev 3).
Master Capable. Latency=64.
Prefetchable 32 bit memory at 0xf8000000 [0xfbffffff].
Bus 0, device 1, function 0:
PCI bridge: Intel Corporation 440BX/ZX - 82443BX/ZX AGP bridge (rev 3).
Master Capable. Latency=128. Min Gnt=140.
Bus 0, device 7, function 0:
ISA bridge: Intel Corporation 82371AB PIIX4 ISA (rev 2).
Bus 0, device 7, function 1:
IDE interface: Intel Corporation 82371AB PIIX4 IDE (rev 1).
Master Capable. Latency=64.
I/O at 0x1000 [0x100f].
Bus 0, device 7, function 2:
USB Controller: Intel Corporation 82371AB PIIX4 USB (rev 1).
IRQ 9.
Master Capable. Latency=64.
I/O at 0x1020 [0x103f].
Bus 0, device 7, function 3:
Bridge: Intel Corporation 82371AB PIIX4 ACPI (rev 2).
Bus 0, device 13, function 0:
Ethernet controller: Digital Equipment Corporation DECchip 21142/43 (rev 65).
IRQ 11.
Master Capable. Latency=165. Min Gnt=20.Max Lat=40.
I/O at 0x1080 [0x10ff].
Non-prefetchable 32 bit memory at 0xf4000000 [0xf40003ff].
Linux version 2.3.99-pre5 (root@pade.jcu.cz) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #2 Fri Apr 14 09:23:46 CEST 2000
e820: 0009f800 @ 00000000 (usable)
e820: 00000800 @ 0009f800 (reserved)
e820: 00019000 @ 000e7000 (reserved)
e820: 01efdc00 @ 00100000 (usable)
e820: 00002000 @ 01ffdc00 (ACPI data)
e820: 00000400 @ 01fffc00 (ACPI NVS)
e820: 00019000 @ fffe7000 (reserved)
On node 0 totalpages: 8189
zone(0): 4096 pages.
zone(1): 4093 pages.
zone(2): 0 pages.
Initializing CPU#0
Detected 399105707 Hz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 796.26 BogoMIPS
Memory: 29976k/32756k available (1120k kernel code, 2392k reserved, 84k data, 160k init, 0k highmem)
Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 8192 (order: 3, 32768 bytes)
CPU: Intel Celeron (Mendocino) stepping 00
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
PCI: PCI BIOS revision 2.10 entry at 0xfd9b4, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Using IRQ router PIIX [8086/122e] at 00:07.0
Limiting direct PCI/PCI transfers.
isapnp: Scanning for Pnp cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.3
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 2048 bind 2048)
IPv6 v0.8 for NET4.0
IPv6 over IPv4 tunneling driver
early initialization of device sit0 is deferred
Initializing RT netlink socket
Starting kswapd v1.6
pty: 256 Unix98 ptys configured
Uniform Multi-Platform E-IDE driver Revision: 6.30
ide: Assuming 40MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0x1000-0x1007, BIOS settings: hda:DMA, hdb:pio
hda: ST33210A, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: 6346368 sectors (3249 MB) w/256KiB Cache, CHS=787/128/63
Partition check:
hda: hda1 hda2 < hda5 hda6 >
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
eth0: DC21143 at 0x1080 (PCI bus 0, device 13), h/w address 00:80:48:cd:77:c2,
and requires IRQ11 (provided by PCI BIOS).
de4x5.c:V0.545 1999/11/28 davies@maniac.ultranet.com
eth0: DC21143 at 0x1400 (PCI bus 0, device 14), h/w address 00:80:48:cd:80:0a,
and requires IRQ10 (provided by PCI BIOS).
de4x5.c:V0.545 1999/11/28 davies@maniac.ultranet.com
eth0: DC21143 at 0x1480 (PCI bus 0, device 15), h/w address 00:80:48:cd:77:17,
and requires IRQ15 (provided by PCI BIOS).
de4x5.c:V0.545 1999/11/28 davies@maniac.ultranet.com
Serial driver version 4.93 (2000-03-20) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
[drm] Initialized tdfx 0.0.1 19991009 on minor 63
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 160k freed
Adding Swap: 68504k swap-space (priority -1)
eth0: media is 100Mb/s.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sat Apr 15 2000 - 21:00:24 EST