2.3.99-pre7-2 -- Still unable to load serial_cs when PCMCIA support is built as a module.

From: Miles Lane (miles@speakeasy.org)
Date: Wed May 03 2000 - 02:05:04 EST


I have a Lucent PCMCIA modem. When I build PCMCIA support as a
module and then load all the drivers, when I try to load serial_cs
I get this error:

May 2 16:12:14 spot kernel: cs: warning: no high memory space
available!
May 2 16:12:14 spot kernel: cs: unable to map card memory!

Here's the kernel log leading up to the failure:

May 2 16:11:17 spot kernel: Adding cardbus controller 0: Texas
Instruments PCI1131
May 2 16:11:17 spot kernel: PCI: No IRQ known for interrupt pin A of
device 00:04.0. Please try using pci=biosirq.
May 2 16:11:17 spot kernel: Yenta IRQ list 0098, PCI irq0
May 2 16:11:17 spot kernel: Socket status: 30000006
May 2 16:11:17 spot kernel: Adding cardbus controller 1: Texas
Instruments PCI1131 (#2)
May 2 16:11:17 spot kernel: PCI: No IRQ known for interrupt pin B of
device 00:04.1. Please try using pci=biosirq.
May 2 16:11:17 spot kernel: Yenta IRQ list 0098, PCI irq0
May 2 16:11:17 spot kernel: Socket status: 30000059
May 2 16:11:54 spot kernel: cs: cb_alloc(bus 1): vendor 0x10b7, device
0x5157
May 2 16:11:54 spot kernel: PCI: Enabling device 01:00.0 (0000 -> 0003)
May 2 16:11:54 spot kernel: PCI: No IRQ known for interrupt pin A of
device 01:00.0. Please try using pci=biosirq.
May 2 16:12:04 spot kernel: 3c59x.c:v0.99L+LK1.1.2+AKPM 24 Apr 2000
Donald Becker and others
http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html
May 2 16:12:04 spot kernel: eth0: 3Com PCI 3CCFE575 Cyclone CardBus at
0x1000, PCI: Increasing latency timer of device 01:00.0 to 64
May 2 16:12:04 spot kernel: 00:10:4b:7c:9d:9d, IRQ 3
May 2 16:12:04 spot kernel: eth0: CardBus functions mapped
10800080->c5844080
May 2 16:12:04 spot kernel: 8K byte-wide RAM 5:3 Rx:Tx split, MII
interface.
May 2 16:12:04 spot kernel: MII transceiver found at address 0,
status 7809.
May 2 16:12:04 spot kernel: 3c59x: Wake-on-LAN functions disabled
May 2 16:12:04 spot kernel: Enabling bus-master transmits and
whole-frame receives.
May 2 16:12:14 spot kernel: cs: warning: no high memory space
available!
May 2 16:12:14 spot kernel: cs: unable to map card memory!

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/



This archive was generated by hypermail 2b29 : Sun May 07 2000 - 21:00:11 EST