I apologize to the list if this message is repeated, recent mail problems
(hopefully now resolved) gave me the impression my first message didn't
make it here.
I have an Adaptec AHA284X VLB scsi controller.
Booting 2.2.16 produced the following error:
(scsi0) <Adaptec AHA-284X SCSI host adapter> found at VLB slot 1
(scsi0) Narrow Channel, SCSI ID=7, 4/255 SCBs
(scsi0) Downloading sequencer code... 416 instructions downloaded
scsi0 : Adaptec AHA274X/284X/294X (EISA/VLB/PCI-FAST SCSI) 5.1.28/3.2.4
<Adaptec AHA-284X SCSI host adapter>
scsi : 1 host.
(scsi0:0:0:0) Synchronous at 10.0 Mbyte/sec, offset 15.
Vendor: FUJITSU Model: M1606S-512 Rev: 6234
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
(scsi0) BRKADRINT error(0x2)
Illegal Sequencer Address referenced
(scsi0) SEQADDR=0x1
Kernel panic: aic7xxx: unrecoverable BRKADRINT
In swapper task - not syncing
####################################################
/usr/src/linux/.config SCSI selections:
CONFIG_SCSI=y
CONFIG_BLK_DEV_SD=y
CONFIG_BLK_DEV_SR=m
CONFIG_BLK_DEV_SR_VENDOR=y
CONFIG_CHR_DEV_SG=m
CONFIG_SCSI_MULTI_LUN=y
CONFIG_SCSI_CONSTANTS=y
CONFIG_SCSI_AIC7XXX=y
CONFIG_AIC7XXX_CMDS_PER_DEVICE=8
CONFIG_AIC7XXX_RESET_DELAY=5
####################################################
The above has worked fine for kernel <= 2.2.14.
I've recompiled twice, using same options. No, I didnt cp over the
old .config from 2.2.14, both recompiles were from freshly untarred
(twice) 2.2.16 src.
Is something else broken, or did I miss something?
----------------------------------------------------
Home & aRDy Music
http://rdb.linux-help.org
----------------------------------------------------
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Thu Jun 15 2000 - 21:00:18 EST