On Wed, Dec 06, 2000 at 04:07:38PM +0100, Olaf Kirch wrote:
> On Wed, Dec 06, 2000 at 02:09:05PM +0100, Andi Kleen wrote:
> > IP_PKTINFO does not allow to set source addresses, only destination
> > addresses. Source address depends on the boundage or the route.
>
> No. At least udp_sendmsg uses the spec_dst_addr field as the source
> address. I added some code to my traceroute that lets you select the
> source address in order to verify that.
Please read the code again.
It uses spec_dst to select the possibly policy sourced route -- the
actual source address is only set from that route (either default or what
was set using ip route's from flag) or the bound address.
> However the good thing is that somewhere something seems to check that
> the requested address is indeed one attached to a local interface.
That's not actually checked, but in most simple routing configurations it is
true.
>
> > > 13:43:02 poll([{fd=4, events=POLLERR}], 1, 5) = 0
> > > 13:43:02 poll([{fd=4, events=POLLERR}], 1, 5) = 0
> > > 13:43:02 poll([{fd=4, events=POLLERR}], 1, 5) = 0
> > > 13:43:02 poll([{fd=4, events=POLLERR}], 1, 5) = 0
> >
> > POLLERR is returned until the error queue is empty. I suspect you're
> > not emptying it properly in all cases. It can contain multiple errors.
>
> But it doesn't return POLLERR. If it was returning it, pollfd.revents
> would be set. pollfd.events is the event mask that's being passed _into_
> the poll() call.
Right. I missed your 5ms timeout @)
-Andi
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Thu Dec 07 2000 - 21:00:15 EST