On Wed, Jan 17, 2001 at 01:33:42PM -0800, Linus Torvalds wrote:
> Did you also remove the two lines that disabled pirq routing if an IO-APIC
> was enabled?
Yesterday not, today yes. But it's the same.
> > Kernel with these changes can't detect my SCSI drive. It prints these messages
> > in cycle:
>
> Which SCSI adapter is this? It may be that you have one of the drivers
> that does not do "pci_enable_dev()" at initialization time..
SCSI storage controller: Adaptec 7899P (rev 0).
IRQ 16.
Master Capable. Latency=72. Min Gnt=40.Max Lat=25.
I/O at 0x5800 [0x58ff].
Non-prefetchable 64 bit memory at 0xfd000000 [0xfd000fff].
Used kernel options:
CONFIG_SCSI=y
CONFIG_BLK_DEV_SD=y
CONFIG_SD_EXTRA_DEVS=40
CONFIG_SCSI_DEBUG_QUEUES=y
CONFIG_SCSI_CONSTANTS=y
CONFIG_SCSI_AIC7XXX=y
CONFIG_AIC7XXX_CMDS_PER_DEVICE=8
CONFIG_AIC7XXX_RESET_DELAY=10
Petr
---------------------------------------------------------------
Petr Matula pem@fi.muni.cz
http://www.fi.muni.cz/~pem
---------------------------------------------------------------
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Tue Jan 23 2001 - 21:00:17 EST