Re: VT82C686A corruption with 2.4.x

From: David Raufeisen (david@fortyoz.org)
Date: Wed Jan 31 2001 - 02:55:25 EST


On Wednesday, 31 January 2001, at 08:36:42 (+0100),
Vojtech Pavlik wrote:

> Hi!
>
> 1) You don't seem to have any drives on the VIA controller. If this is
> true, I don't think this can be a VIA IDE driver problem.
>

Hi, Are you referring to Mark or me?

I have drives on my VIA (only..) IDE controller:

VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: chipset revision 16
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt82c686a IDE UDMA66 controller on pci0:7.1
VP_IDE: ATA-66/100 forced bit set (WARNING)!!
    ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:DMA
VP_IDE: ATA-66/100 forced bit set (WARNING)!!
    ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:pio
hda: Maxtor 51536H2, ATA DISK drive
hdb: Maxtor 94098U8, ATA DISK drive
hdc: CD-ROM 52X/AKH, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 30015216 sectors (15368 MB) w/2048KiB Cache, CHS=1868/255/63, UDMA(66)
hdb: 80041248 sectors (40981 MB) w/2048KiB Cache, CHS=4982/255/63, UDMA(66)
hdc: ATAPI 52X CD-ROM drive, 192kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
Partition check:
 hda: hda1 hda2
 hdb: hdb1
 
> 2) In your original message you suggest bs=1024M, which isn't a very
> good idea, even on a 768 MB system. Here with bs=1024k it seems to run
> fine.
>
> 3) You sent next to none VIA related debugging info. lspci -v itself
> isn't much valuable because I don't get the register contents. Also
> hdparm -i of the drives attached to the VIA chip would be useful. Plus
> also the contents of /proc/ide/via.

I didn't supply anything either, even though my configuration works great it
might prove useful to someone comparing:

bash-2.04# hdparm -i /dev/hda

/dev/hda:

 Model=Maxtor 51536H2, FwRev=JAC61HU0, SerialNo=F203VTHC
 Config={ Fixed }
 RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=57
 BuffType=DualPortCache, BuffSize=2048kB, MaxMultSect=16, MultSect=off
 CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=30015216
 IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
 PIO modes: pio0 pio1 pio2 pio3 pio4
 DMA modes: mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 *udma4 udma5
bash-2.04# hdparm -i /dev/hdb

/dev/hdb:

 Model=Maxtor 94098U8, FwRev=FA500S60, SerialNo=G8066RQC
 Config={ Fixed }
 RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=57
 BuffType=DualPortCache, BuffSize=2048kB, MaxMultSect=16, MultSect=off
 CurCHS=17475/15/63, CurSects=16513875, LBA=yes, LBAsects=80041248
 IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
 PIO modes: pio0 pio1 pio2 pio3 pio4
 DMA modes: mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 *udma4
bash-2.04#

bash-2.04# cat /proc/ide/via
----------VIA BusMastering IDE Configuration----------------
Driver Version: 2.1e
South Bridge: VIA vt82c686a rev 0x22
Command register: 0x7
Latency timer: 32
PCI clock: 33MHz
Master Read Cycle IRDY: 0ws
Master Write Cycle IRDY: 0ws
FIFO Output Data 1/2 Clock Advance: off
BM IDE Status Register Read Retry: on
Max DRDY Pulse Width: No limit
-----------------------Primary IDE-------Secondary IDE------
Read DMA FIFO flush: on on
End Sect. FIFO flush: on on
Prefetch Buffer: on on
Post Write Buffer: on on
FIFO size: 8 8
Threshold Prim.: 1/2 1/2
Bytes Per Sector: 512 512
Both channels togth: yes yes
-------------------drive0----drive1----drive2----drive3-----
BMDMA enabled: yes yes yes no
Transfer Mode: UDMA UDMA UDMA DMA/PIO
Address Setup: 30ns 30ns 30ns 120ns
Active Pulse: 90ns 90ns 90ns 330ns
Recovery Time: 30ns 30ns 30ns 270ns
Cycle Time: 30ns 30ns 60ns 600ns
Transfer Rate: 66.0MB/s 66.0MB/s 33.0MB/s 3.3MB/s

bash-2.04# lspci -v (trimmed)
00:00.0 Host bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133] (rev 02)
        Flags: bus master, medium devsel, latency 8
        Memory at e0000000 (32-bit, prefetchable) [size=64M]
        Capabilities: [a0] AGP version 2.0
        Capabilities: [c0] Power Management version 2

00:01.0 PCI bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133 AGP] (prog-if 00 [Normal decode])
        Flags: bus master, 66Mhz, medium devsel, latency 0
        Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
        I/O behind bridge: 00009000-00009fff
        Memory behind bridge: dde00000-dfefffff
        Prefetchable memory behind bridge: cdc00000-ddcfffff
        Capabilities: [80] Power Management version 2

00:07.0 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super South] (rev 22)
        Subsystem: VIA Technologies, Inc. VT82C686/A PCI to ISA Bridge
        Flags: bus master, stepping, medium devsel, latency 0

00:07.1 IDE interface: VIA Technologies, Inc. Bus Master IDE (rev 10) (prog-if 8a [Master SecP PriP])
        Flags: bus master, medium devsel, latency 32
        I/O ports at ffa0 [size=16]
        Capabilities: [c0] Power Management version 2

00:07.2 USB Controller: VIA Technologies, Inc. UHCI USB (rev 10) (prog-if 00 [UHCI])
        Subsystem: Unknown device 0925:1234
        Flags: bus master, medium devsel, latency 64, IRQ 9
        I/O ports at cc00 [size=32]
        Capabilities: [80] Power Management version 2

00:07.3 USB Controller: VIA Technologies, Inc. UHCI USB (rev 10) (prog-if 00 [UHCI])
        Subsystem: Unknown device 0925:1234
        Flags: bus master, medium devsel, latency 64, IRQ 9
        I/O ports at d000 [size=32]
        Capabilities: [80] Power Management version 2

00:07.4 SMBus: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI] (rev 30)
        Flags: medium devsel
        Capabilities: [68] Power Management version 2

> 4) Did you check the problem you're experiencing isn't a memory problem?
> That'd go away with removing some RAM.

I assume this was to Mark, I have no problem:)
 
> Vojtech Pavlik
> SuSE Labs

-- 
David Raufeisen <david@fortyoz.org>
Cell: (604) 818-3596
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
Please read the FAQ at http://www.tux.org/lkml/



This archive was generated by hypermail 2b29 : Wed Jan 31 2001 - 21:00:38 EST