Linux version 2.4.3-ac3 (root@psubash) (gcc version 2.95.2.1 19991024 (release)) #12 Thu Apr 5 15:30:39 PDT 2001 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009f800 (usable) BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved) BIOS-e820: 00000000000e7000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000007ffdc00 (usable) BIOS-e820: 0000000007ffdc00 - 0000000007fffc00 (ACPI data) BIOS-e820: 0000000007fffc00 - 0000000008000000 (ACPI NVS) BIOS-e820: 00000000fffe7000 - 0000000100000000 (reserved) On node 0 totalpages: 32765 zone(0): 4096 pages. zone(1): 28669 pages. zone(2): 0 pages. Local APIC disabled by BIOS -- reenabling. Found and enabled local APIC! Kernel command line: BOOT_IMAGE=acpi ro root=305 Initializing CPU#0 Detected 548.744 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 1094.45 BogoMIPS Memory: 126400k/131060k available (1185k kernel code, 4272k reserved, 446k data, 204k init, 0k highmem) Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes) Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes) Page-cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 8192 (order: 4, 65536 bytes) CPU: Before vendor init, caps: 0387fbff 00000000 00000000, vendor = 0 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 512K Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After vendor init, caps: 0387fbff 00000000 00000000 00000000 CPU serial number disabled. CPU: After generic, caps: 0383fbff 00000000 00000000 00000000 CPU: Common caps: 0383fbff 00000000 00000000 00000000 CPU: Intel Pentium III (Katmai) stepping 03 Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX enabled ExtINT on CPU#0 ESR value before enabling vector: 00000040 ESR value after enabling vector: 00000000 Using local APIC timer interrupts. calibrating APIC timer ... ..... CPU clock speed is 548.7596 MHz. ..... host bus clock speed is 99.7742 MHz. cpu: 0, clocks: 997742, slice: 498871 CPU0 mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel PCI: PCI BIOS revision 2.10 entry at 0xfd9b4, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware Unknown bridge resource 0: assuming transparent PCI: Using IRQ router PIIX [8086/7110] at 00:07.0 Limiting direct PCI/PCI transfers. Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd v1.8 pty: 256 Unix98 ptys configured block: queued sectors max/low 83949kB/27983kB, 256 slots per queue Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx PIIX4: IDE controller on PCI bus 00 dev 39 PIIX4: chipset revision 1 PIIX4: not 100% native mode: will probe irqs later hda: IBM-DPTA-372050, ATA DISK drive hdc: CREATIVE CD5230E, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: 40088160 sectors (20525 MB) w/1961KiB Cache, CHS=2495/255/63 hdc: ATAPI 52X CD-ROM drive, 128kB Cache Uniform CD-ROM driver Revision: 3.12 Partition check: hda: hda1 hda2 < hda5 hda6 > Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 Serial driver version 5.05 (2000-12-13) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A PCI: Found IRQ 5 for device 00:0f.0 3c59x.c:LK1.1.13 27 Jan 2001 Donald Becker and others. http://www.scyld.com/network/vortex.html See Documentation/networking/vortex.txt eth0: 3Com PCI 3c905B Cyclone 100baseTx at 0x1000, 00:50:da:82:0e:5e, IRQ 5 product code 5842 rev 00.12 date 11-13-99 8K byte-wide RAM 5:3 Rx:Tx split, autoselect/Autonegotiate interface. MII transceiver found at address 24, status 786d. Enabling bus-master transmits and whole-frame receives. eth0: scatter/gather enabled. h/w checksums enabled Linux agpgart interface v0.99 (c) Jeff Hartmann agpgart: Maximum main memory to use for agp memory: 94M agpgart: Detected Intel 440BX chipset agpgart: AGP aperture is 64M @ 0xf8000000 Creative EMU10K1 PCI Audio Driver, version 0.7, 12:19:15 Apr 5 2001 PCI: Found IRQ 10 for device 00:0e.0 emu10k1: EMU10K1 rev 7 model 0x8027 found, IO at 0x10a0-0x10bf, IRQ 10 Linux PCMCIA Card Services 3.1.22 options: [pci] [cardbus] [pm] usb.c: registered new driver hub PCI: Found IRQ 9 for device 00:07.2 uhci.c: USB UHCI at I/O 0x1080, IRQ 9 usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected ACPI: Core Subsystem version [20010208] ACPI: Subsystem enabled ACPI: System firmware supports: C2 C3 ACPI: plvl2lat=10 plvl3lat=20 ACPI: C2 enter=143 C2 exit=35 ACPI: C3 enter=858 C3 exit=71 ACPI: Using ACPI idle ACPI: If experiencing system slowness, try adding "acpi=no-idle" to cmdline ACPI: System firmware supports: S0 S1 S5 NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 8192 bind 8192) eth0: using NWAY device table, not 8 IP-Config: Incomplete network configuration information. NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. ds: no socket drivers loaded! VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 204k freed Adding Swap: 136512k swap-space (priority -1) eth0: using NWAY device table, not 8