I've got an "Adaptec AHA-2940UW Pro Ultra SCSI host adapter" using
the aic7xxx driver (the new one, not the old one), and have had no
problems, I have a zip drive on ID5, and a 12X Smart & Friendly CD-RW on
ID6, haven't had any problems on 2.4.3-ac14, or 2.4.4, just an FYI.
Matthew S. Hallacy
> Getting the same errors here, but only a few seconds after my adaptec gets initialized and all disks/cdrs/zips get attached + mounted. On 2.4.3-ac14 it only gives these errors and happily runs afterwards. But on 2.4.4 it panics after $random time.
> My setup is a P2B-S motherboard with a Quantum Fireball ST 6.4 GB HDD
> scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.1.11
> <Adaptec aic7890/91 Ultra2 SCSI adapter>
> aic7890/91: Wide Channel A, SCSI Id=7, 32/255 SCBs
> Vendor: QUANTUM Model: FIREBALL ST6.4S Rev: 0F0C
> Type: Direct-Access ANSI SCSI revision: 02
> (scsi0:A:0): 20.000MB/s transfers (20.000MHz, offset 15)
> And the specific errors are
> scsi0:0:0:0: Attempting to queue a TARGET RESET message
> scsi0:0:0:0: Command not found
> aic7xxx_dev_reset returns 8194
> Device not ready. Make sure there is a disc in the drive.
> > Then, the Kernel detects the SECOND SCSI disk and attaches it as sda
> > (Linux 2.2 would mount that as sdb), the first disk is "gone" (Linux 2.2
> > would mount that as sda). Regretfully, my root partition is on the
> > FIRST SCSI disk, so the kernel panicks since it cannot mount /.
> > That's all I copied in a hurry, maybe it's sufficient to debug, if not,
> > I can try to grab a null modem cable and catch the full sequence; I'd be
> > glad if someone could mention the "canonical" aic7xxx LILO append
> > parameters for a full debug trace in that case.
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to firstname.lastname@example.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Mon Apr 30 2001 - 21:00:21 EST