I'm not entirely sure if this is ac15's fault or the preempt patch acting up.
But this is very ide-scsi centric so i'm leaning towards ac15. I burned a cd
using my ide writer and it worked fine. Then i went to burn another and the
drive went into an infinite reset loop. like this.
SCSI bus is being reset for host 0 channel 0.
scsi0 : channel 0 target 0 lun 0 request sense failed, performing reset.
reloading the modules does nothing but report this error.
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
scsi0 : channel 0 target 0 lun 0 request sense failed, performing reset.
SCSI bus is being reset for host 0 channel 0.
Even though the modules were removed, the drive led is still blinking like it
was writing. If anyone needs some more info i'll try and get it.
the cdr did detect and work correctly at boot.
hardware:
Promise ide controller :
PDC20262: chipset revision 1
PDC20262: not 100% native mode: will probe irqs later
PDC20262: (U)DMA Burst Bit ENABLED Primary PCI Mode Secondary PCI Mode.
CDR:
hde: CREATIVE CD-RW RW8438E, ATAPI CD/DVD-ROM drive
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
Vendor: CREATIVE Model: CD-RW RW8438E Rev: FC03
Type: CD-ROM ANSI SCSI revision: 02
software:
Cdrecord 1.10 (i686-pc-linux-gnu) Copyright (C) 1995-2001 Jörg Schilling
linux-2.4.9-ac15-preempt-fix
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sun Sep 30 2001 - 21:01:00 EST