I have a USB printer that was working fine with 2.4.10-ac7.
Just switched to 2.4.10-ac11 and now I get the following at usb-uhci's
modprobe:
/var/log/messages
Oct 11 16:32:17 stratus kernel: usb-uhci.c: $Revision: 1.259 $ time 14:24:14 Oct 11 2001
Oct 11 16:32:17 stratus kernel: usb-uhci.c: High bandwidth mode enabled
Oct 11 16:32:17 stratus kernel: PCI: Found IRQ 10 for device 00:07.2
Oct 11 16:32:17 stratus kernel: usb-uhci.c: USB UHCI at I/O 0xd400, IRQ 10
Oct 11 16:32:17 stratus kernel: usb-uhci.c: Detected 2 ports
Oct 11 16:32:17 stratus kernel: usb.c: new USB bus registered, assigned bus number 1
Oct 11 16:32:17 stratus kernel: hub.c: USB hub found
Oct 11 16:32:17 stratus kernel: hub.c: 2 ports detected
Oct 11 16:32:17 stratus kernel: usb-uhci.c: v1.251:USB Universal Host Controller Interface driver
Oct 11 16:32:17 stratus kernel: hub.c: USB new device connect on bus1/1, assigned device number 2
Oct 11 16:32:20 stratus kernel: usb_control/bulk_msg: timeout
Oct 11 16:32:20 stratus kernel: usb.c: USB device not accepting new address=2 (error=-110)
Oct 11 16:32:21 stratus kernel: hub.c: USB new device connect on bus1/1, assigned device number 3
Oct 11 16:32:24 stratus kernel: usb_control/bulk_msg: timeout
Oct 11 16:32:24 stratus kernel: usb.c: USB device not accepting new address=3 (error=-110)
/proc/interrupts
CPU0
0: 727719 XT-PIC timer
1: 14394 XT-PIC keyboard
2: 0 XT-PIC cascade
4: 56134 XT-PIC serial
10: 10449 XT-PIC usb-uhci
11: 21430 XT-PIC eth0
14: 45469 XT-PIC ide0
15: 2 XT-PIC ide1
NMI: 0
ERR: 0
NOTE: via82cxxx_audio is using the same IRQ (10) when loaded. But the error is
the same with or without via82cxxx.
Sergio Bruder
--
http://pontobr.org, http://sergio.bruder.net, http://bruder.homeip.net:81
-----------------------------------------------------------------------------
pub 1024D/0C7D9F49 2000-05-26 Sergio Devojno Bruder <sergio@bruder.net>
Key fingerprint = 983F DBDF FB53 FE55 87DF 71CA 6B01 5E44 0C7D 9F49
sub 1024g/138DF93D 2000-05-26
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Mon Oct 15 2001 - 21:00:41 EST