CPU: Intel Pentium II (Deschutes) stepping 03
Enabling fast FPU save and restore... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
PCI: PCI BIOS revision 2.10 entry at 0xfdb81, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
Limiting direct PCI/PCI transfers.
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Starting kswapd
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
request_module[parport_lowlevel]: Root fs not mounted
lp: driver loaded but no devices found
block: 128 slots per queue, batch=32
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:pio, hdd:pio
PDC20268: IDE controller on PCI bus 00 dev a0
PDC20268: chipset revision 1
PDC20268: not 100% native mode: will probe irqs later
PDC20268: ROM enabled at 0xfebf0000
PDC20268: (U)DMA Burst Bit ENABLED Primary MASTER Mode Secondary MASTER Mode.
    ide2: BM-DMA at 0xef60-0xef67, BIOS settings: hde:pio, hdf:pio
    ide3: BM-DMA at 0xef68-0xef6f, BIOS settings: hdg:pio, hdh:pio
hda: IBM-DPTA-372050, ATA DISK drive
hde: MAXTOR 6L040L2, ATA DISK drive
hdg: Maxtor 32049H2, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide2 at 0xeff0-0xeff7,0xefe6 on irq 5
ide3 at 0xefa8-0xefaf,0xefe2 on irq 5
hda: 40088160 sectors (20525 MB) w/1961KiB Cache, CHS=2495/255/63, UDMA(33)
hde: 78177792 sectors (40027 MB) w/1820KiB Cache, CHS=77557/16/63, UDMA(100)
hdg: 40021632 sectors (20491 MB) w/2048KiB Cache, CHS=39704/16/63, UDMA(100)
Partition check:
 hda: hda1 hda2 < hda5 hda6 hda7 hda8 hda9 hda10 hda11 >
 hde: unknown partition table
 hdg: [PTBL] [2491/255/63] hdg1 hdg2
8139too Fast Ethernet driver 0.9.22
eth0: RealTek RTL8139 Fast Ethernet at 0xcc800e00, 00:40:95:30:73:83, IRQ 9
eth0:  Identified 8139 chip type 'RTL-8139C'
SCSI subsystem driver Revision: 1.00
scsi0 : AdvanSys SCSI 3.3G: PCI Ultra: IO 0xE800-0xE80F, IRQ 0xA
  Vendor: YAMAHA    Model: CRW8824S          Rev: 1.00
  Type:   CD-ROM                             ANSI SCSI revision: 02
Attached scsi CD-ROM sr0 at scsi0, channel 0, id 6, lun 0
sr0: scsi3-mmc drive: 24x/16x writer cd/rw xa/form2 cdda tray
Uniform CD-ROM driver Revision: 3.12
md: raid1 personality registered as nr 3
md: multipath personality registered as nr 7
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 228k freed
Adding Swap: 136512k swap-space (priority -1)
Adding Swap: 136512k swap-space (priority -2)
eth0: Setting 100mbps full-duplex based on auto-negotiated partner ability 45e1.