Why is that 'hda: DMA disabled' message in my boot messages? Further on
DMA is enabled on hda - I don't understand what this message means.
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller at PCI slot 00:07.1
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci00:07.1
ide0: BM-DMA at 0xa000-0xa007, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xa008-0xa00f, BIOS settings: hdc:pio, hdd:pio
PDC20265: IDE controller at PCI slot 00:09.0
PDC20265: chipset revision 2
PDC20265: not 100% native mode: will probe irqs later
PDC20265: (U)DMA Burst Bit DISABLED Primary PCI Mode Secondary PCI Mode.
PDC20265: FORCING BURST BIT 0x00->0x01 ACTIVE
ide2: BM-DMA at 0xbc00-0xbc07, BIOS settings: hde:DMA, hdf:pio
ide3: BM-DMA at 0xbc08-0xbc0f, BIOS settings: hdg:pio, hdh:DMA
HPT370: IDE controller at PCI slot 00:0e.0
HPT370: chipset revision 3
HPT370: not 100% native mode: will probe irqs later
HPT37X: using 33MHz PCI clock
ide4: BM-DMA at 0xe000-0xe007, BIOS settings: hdi:DMA, hdj:pio
ide5: BM-DMA at 0xe008-0xe00f, BIOS settings: hdk:DMA, hdl:pio
hda: Maxtor 33073H3, ATA DISK drive
hda: DMA disabled
blk: queue c03b2940, I/O limit 4095Mb (mask 0xffffffff)
hde: IBM-DTLA-307045, ATA DISK drive
blk: queue c03b3268, I/O limit 4095Mb (mask 0xffffffff)
hdg: LITE-ON LTR-40125W, ATAPI CD/DVD-ROM drive
hdi: Maxtor 4G120J6, ATA DISK drive
blk: queue c03b3b90, I/O limit 4095Mb (mask 0xffffffff)
hdk: Maxtor 4G120J6, ATA DISK drive
blk: queue c03b4024, I/O limit 4095Mb (mask 0xffffffff)
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide2 at 0xac00-0xac07,0xb002 on irq 16
ide3 at 0xb400-0xb407,0xb802 on irq 16
ide4 at 0xd000-0xd007,0xd402 on irq 18
ide5 at 0xd800-0xd807,0xdc02 on irq 18
hda: host protected area => 1
hda: 60032448 sectors (30737 MB) w/2048KiB Cache, CHS=3736/255/63, UDMA(100)
hde: host protected area => 1
hde: 90069840 sectors (46116 MB) w/1916KiB Cache, CHS=89355/16/63, UDMA(100)
hdi: host protected area => 1
hdi: 240121728 sectors (122942 MB) w/2048KiB Cache, CHS=14946/255/63, UDMA(100)
hdk: host protected area => 1
hdk: 240121728 sectors (122942 MB) w/2048KiB Cache, CHS=14946/255/63, UDMA(100)
ide-cd: passing drive hdg to ide-scsi emulation.
Partition check:
hda: hda1 hda2 < hda5 hda6 hda7 hda8 hda9 hda10 hda11 >
hde:<6> [PTBL] [5606/255/63] hde1 hde2
hdi: hdi1 hdi2
hdk: hdk1 hdk2 hdk3
SCSI subsystem driver Revision: 1.00
Kind regards,
Jurriaan
-- "I suspect that he regrets nothing." "Not until we catch him, at any rate." "He'll regret getting caught," said Scharde. "No doubt as to that." Jack Vance - Araminta Station GNU/Linux 2.4.20-pre5-ac6 SMP/ReiserFS 2x1402 bogomips load av: 0.37 0.14 0.05 - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sun Sep 15 2002 - 22:00:32 EST