Re: 2.5.37 oopses at boot in ide_toggle_bounce

From: Jens Axboe (axboe@suse.de)
Date: Mon Sep 30 2002 - 08:51:30 EST


On Mon, Sep 30 2002, Andries Brouwer wrote:
> On Mon, Sep 23, 2002 at 12:04:24PM +0200, Jens Axboe wrote:
> > > On Mon, Sep 23 2002, Andries Brouwer wrote:
>
> > > > It no longer sees my disks on an HPT366,
>
> > > Can you send me the kernel boot log
> >
> > Ah hang on, please boot with this patch from Ivan.
>
> Patch makes no difference.
>
> Situation:
> no special kernel boot parameters concerning these disks,
> no hdparm used
> no CONFIG_BLK_DEV_HPT366
>
> For 2.5.33:
>
> HPT366: IDE controller on PCI bus 00 dev 48
> HPT366: detected chipset, but driver not compiled in!
> HPT366: chipset revision 1
> HPT366: not 100%% native mode: will probe irqs later
> ide2: BM-DMA at 0x9c00-0x9c07, BIOS settings: hde:pio, hdf:pio
> HPT366: IDE controller on PCI bus 00 dev 49
> HPT366: chipset revision 1
> HPT366: not 100%% native mode: will probe irqs later
> ide3: BM-DMA at 0xa800-0xa807, BIOS settings: hdg:pio, hdh:pio
>
> For 2.5.38:
> The string HPT does not occur in the boot log.
>
> For 2.5.38 with CONFIG_BLK_DEV_HPT366:
> all OK at first sight, the disks mount, have not tried to stress them
> warnings in boot.log:
>
> HPT366: chipset revision 1
> HPT366: not 100%% native mode: will probe irqs later
> ide2: BM-DMA at 0x9c00-0x9c07, BIOS settings: hde:DMA, hdf:DMA
> hde: Maxtor 93652U8, ATA DISK drive
> hdf: Maxtor 96147H6, ATA DISK drive
> hde: set_drive_speed_status: status=0x51 { DriveReady SeekComplete Error }
> hde: set_drive_speed_status: error=0x04 { DriveStatusError }
> hdf: set_drive_speed_status: status=0x51 { DriveReady SeekComplete Error }
> hdf: set_drive_speed_status: error=0x04 { DriveStatusError }
>
> Funny that 2.5.33 reports "BIOS settings: hde:pio, hdf:pio"
> while 2.5.38 says "BIOS settings: hde:DMA, hdf:DMA".
>
> Long ago I would get (sporadic) disk errors and fs corruption with
> CONFIG_BLK_DEV_HPT366, while all worked without. Today
> CONFIG_BLK_DEV_HPT366 is required, but apart from the messages quoted
> I have not seen any error messages or problems. Everything works.
>
> Precisely the same holds for 2.5.39.

Does it work in 2.4.20-pre-ac?

-- 
Jens Axboe

- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/



This archive was generated by hypermail 2b29 : Mon Sep 30 2002 - 22:00:45 EST