4) USB no longer working. Was working fine in vanilla test4.
drivers/usb/host/uhci-hcd.c: USB Universal Host Controller Interface driver v2.1
uhci-hcd 0000:00:11.2: UHCI Host Controller
irq 11: nobody cared!
Call Trace:
[<c010cbdb>] __report_bad_irq+0x2b/0x90
[<c010ccd4>] note_interrupt+0x64/0xa0
[<c010cf6e>] do_IRQ+0x12e/0x140
[<c010b49c>] common_interrupt+0x18/0x20
[<c0124603>] do_softirq+0x43/0xa0
[<c010cf48>] do_IRQ+0x108/0x140
[<c010b49c>] common_interrupt+0x18/0x20
[<c01add8c>] pci_bus_write_config_word+0x5c/0x80
[<cf9f94a0>] uhci_reset+0x40/0x50 [uhci_hcd]
[<cf8a6a32>] usb_hcd_pci_probe+0x192/0x480 [usbcore]
[<c01b176b>] pci_device_probe_static+0x4b/0x60
[<c01b18d6>] __pci_device_probe+0x36/0x50
[<c01b191c>] pci_device_probe+0x2c/0x50
[<c01f5dad>] bus_match+0x3d/0x70
[<c01f5f00>] driver_attach+0x70/0xb0
[<c01f6201>] bus_add_driver+0xa1/0xc0
[<c01f6651>] driver_register+0x31/0x40
[<c01b1b9e>] pci_register_driver+0x5e/0x90
[<cf8e90c7>] uhci_hcd_init+0xc7/0x143 [uhci_hcd]
[<c0137043>] sys_init_module+0x123/0x270
[<c010b32f>] syscall_call+0x7/0xb
handlers:
[<cf91c4b0>] (snd_via82xx_interrupt+0x0/0x110 [snd_via82xx])
Disabling IRQ #11
uhci-hcd 0000:00:11.2: irq 11, io base 0000d400
uhci-hcd 0000:00:11.2: new USB bus registered, assigned bus number 1
hub 1-0:0: USB hub found
hub 1-0:0: 2 ports detected
uhci-hcd 0000:00:11.3: UHCI Host Controller
uhci-hcd 0000:00:11.3: irq 11, io base 0000d800
uhci-hcd 0000:00:11.3: new USB bus registered, assigned bus number 2
hub 2-0:0: USB hub found
hub 2-0:0: 2 ports detected
hub 1-0:0: debounce: port 1: delay 100ms stable 4 status 0x301
hub 1-0:0: new USB device on port 1, assigned address 2
usb 1-1: control timeout on ep0out
uhci-hcd 0000:00:11.2: Unlink after no-IRQ? Different ACPI or APIC settings may help.