sungem issues

From: Badinter, George
Date: Thu Nov 20 2003 - 19:01:56 EST


I am running 2.4-22 on x86 with Sun GigE Card. The card seemed to
recognized fined and I see it come up. However,
it doesn't want to play nice with Cisco 3500XL switch. I have tried
several port setting on the switch's port i.e.
autoneg off/on duplex full/half and etc. I see link lights, ethtool says
that the link is up, but there is no traffic coming through.
This brings me to the interesting point, apparently sungem driver was
fixed from 2.4-19 to 2.4-22, however ethtool still
has no effect on it. No matter, how much I tried to play with it, it
will not change any settings on sungem interface. It comes
at 100 Full Duplex, autoneg on.

Has anyone able to make this card work under 2.4-22??? Please help!!

Here some outputs:

lspci -vv

00:08.0 Ethernet controller: Sun Microsystems Computer Corp. GEM (rev
01)
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=slow >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (16000ns min, 16000ns max), cache line size 10
Interrupt: pin A routed to IRQ 16
Region 0: Memory at f4000000 (32-bit, non-prefetchable)
[size=2M]
Expansion ROM at 40000000 [size=1M]
[root@luke root]# lsmod
Module Size Used by Not tainted
autofs 13748 0 (autoclean) (unused)
sungem 27468 1
3c59x 30576 1
iptable_filter 2412 0 (autoclean) (unused)
ip_tables 16032 1 [iptable_filter]
mousedev 5624 0 (unused)
keybdev 2912 0 (unused)
input 6080 0 [mousedev keybdev]
hid 12380 0 (unused)
usb-ohci 21896 0 (unused)
usbcore 80960 1 [hid usb-ohci]
ext3 73124 3
jbd 56080 3 [ext3]
raid0 3848 1


[root@luke root]# ifconfig eth1
eth1 Link encap:Ethernet HWaddr 00:03:BA:16:26:55
inet addr:192.168.0.81 Bcast:192.168.0.255
Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:4294967251
TX packets:0 errors:0 dropped:0 overruns:0 carrier:4294967281
collisions:4294967266 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:16 Base address:0x5400
[root@luke root]# ethtool eth1
Settings for eth1:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: Not reported
Advertised auto-negotiation: No
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 0
Transceiver: externel
Auto-negotiation: on
Current message level: 0x00000007 (7)
Link detected: yes

Thanks again.

George
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/