Re: Errors and later panics in 2.6.0-test11.

[Jens Axboe]

On Thu, Dec 04 2003, Jens Axboe wrote:
> On Wed, Dec 03 2003, Linus Torvalds wrote:
> > 
> > 
> > On Wed, 3 Dec 2003, David Martínez Moreno wrote:
> > >
> > > 	I've just rebooted about six hours ago, and it's giving panics elsewhere:
> > >
> > > [...]
> > > Ending XFS recovery on filesystem: md0 (dev: md0)
> > > b44: eth0: Link is down.
> > > b44: eth0: Link is up at 100 Mbps, full duplex.
> > > b44: eth0: Flow control is on for TX and on for RX.
> > > eth0: no IPv6 routers present
> > > Unable to handle kernel paging request at virtual address 00100104
> > 
> > That's the LIST_POISON stuff: 00100100 is the "bad list pointer". Somebody
> > tried to remove a page twice.
> > 
> > Doesn't mean a lot - if your "struct page" got corrupted, anything can
> > happen. Quite possibly it's a double free.
> > 
> > > 	I can rebuild the Debian mirror for not using the RAID and using the SATA
> > > disks separately, but will be tomorrow, it's a lot of space to move, and I
> > > need remote intervention.
> > >
> > > 	Anyway I'd love to know before doing if it will be useful, looking at what
> > > Jens has said just ten minutes ago about RAIDs 0/5. Will it help to you? Say
> > > so and I'll go for it.
> > 
> > It might be more useful to leave it as RAID0, if you're willing to try out
> > patches to try to debug this. The slab-debugging thing I sent out earlier
> > is one such patch (but may well cause out-of-memory problems under load),
> > and possibly the atomic-decrement checker patch (appended). And maybe Jens
> > and Neil can come up with something..
> 
> I can reproduce on raid5 with linear dm on top (using XFS). I need to
> kill the slab and memory debugging, I've put some bio debugging in there
> instead (the memory debugging interferes with it). It's definitely a bio
> use after free case, clone_endio() ends up with a freed bio.
> 
> Program received signal SIGEMT, Emulation trap.
> 0xc02dd454 in handle_stripe (sh=0xc17cf630) at drivers/md/raid5.c:1009
> 1009                                        wbi = wbi2;
> (gdb) bt
> #0  0xc02dd454 in handle_stripe (sh=0xc17cf630) at drivers/md/raid5.c:1009
> #1  0xc02de31f in raid5d (mddev=0xdfd2d200) at drivers/md/raid5.c:1436
> #2  0xc02e675a in md_thread (arg=0xdffdc1a0) at drivers/md/md.c:2692
> #3  0xc010752d in kernel_thread_helper () at arch/i386/kernel/process.c:226
> 
> wbi (dev->written) has already been freed by someone else.
> 
> My puny 512MB test box cannot use your slab-debug patch :). The
> atomic-checker didn't catch anything.

I can just as easily reproduce with ext2, so I don't think XFS has
anything to do with it. This is still raid5 with dm linear on top.

(gdb) bt
#0  0x0b10dead in ?? ()
#1  0xc0170e25 in bio_endio (bio=0xda37fae0, bytes_done=0, error=0)
    at fs/bio.c:689
#2  0xc02e8a0d in clone_endio (bio=0xda38c120, done=7168, error=0)
    at drivers/md/dm.c:266
#3  0xc02dd78c in handle_stripe (sh=0xdfc18de0) at drivers/md/raid5.c:1209
#4  0xc02de38f in raid5d (mddev=0xdfd62200) at drivers/md/raid5.c:1437
#5  0xc02e67da in md_thread (arg=0xdfd58260) at drivers/md/md.c:2692
#6  0xc010752d in kernel_thread_helper () at arch/i386/kernel/process.c:226
(gdb) p *(struct bio *) 0xda37fae0
$1 = {bi_sector = 42974, bi_next = 0x0, bi_bdev = 0xb10dead, bi_flags =
1041, 
  bi_rw = 1, bi_vcnt = 3, bi_idx = 0, bi_phys_segments = 0, 
  bi_hw_segments = 0, bi_size = 0, bi_max_vecs = 0, bi_io_vec =
0xda357ce0, 
  bi_end_io = 0xb10dead, bi_cnt = {counter = 0}, bi_private = 0xb10dead, 
  bi_destructor = 0xc0170050 <bio_destructor>, free_eip = 0xc02e8a26}

EIP is bad, bio debug magic 0x0b10dead. bi_flags has the uptodate bit
set, the clone bit, and the 10th bit (debug dead bit). The bio itself
was freed by 0xc02e8a26, dm.c:clone_endio().

-- 
Jens Axboe

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/