Re: TG3: very high CPU usage

From: Tom Sightler
Date: Tue Jan 20 2004 - 22:23:23 EST


On Tue, 2004-01-20 at 18:13, Lincoln Dale wrote:
> At 11:33 PM 20/01/2004, JG wrote:
> >i have also two boxes (one with 2.6.0, the other one 2.6.1-mm2) equipped
> >with netgear ga302t cards (x-over cable).
> >i don't see a very high cpu usage, but since upgrading to 2.6.x kernels i
> >sometimes have really weird speed issues. i often only get transfer rates
> >of about ~200-300 kilobytes/second...yes, and this over a gigabit
> >interface, tested over ftp.
> >i'm also running a nfs server on the 2.6.1-mm2 box, the 2.6.0 pc is the
> >client, but again, sometimes it's *very* slow. if i reboot my 2.6.1-mm2
> >box (the other one is a server which can't be rebooted) it seems to be
> >fine for some time.
> >
> >i didn't have such problems with 2.4.19 kernels on both pcs, there i got
> >about 30-35MB/s over ftp without any problems, so i don't think it's
> >hardware related.

I'm curious is the people seeing this problem happen to have preempt
enabled in their config. I've noticed that my laptop, which also
happens to have a tg3 based 10/100/1000 card, uses tons of CPU during
trasfers, but only when preempt is enabled.

After looking into this, my Aironet wireless has exactly the same
problem. When preempt is enabled a simple scp transfer running at
approximately maximum speed for 802.11b (7.5Mb/sec) uses almost 70% of
the CPU. The tg3 driver doing the same scp at 40Mb/sec (100Mb ethernet)
uses > 90% of the CPU.

However, turning off preempt and my system runs at approximately the
same speed on wireless (7.5Mb/sec) but only about 5% CPU. The tg3
driver with preempt disabled allows the scp to run at near wire speed
(95-100Mb/sec) and uses only a fraction of the CPU.

Just curious if this might be what others are seeing.

Later,
Tom


-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/