Re: TG3: very high CPU usage
From: Lincoln Dale
Date: Sat Jan 31 2004 - 19:22:02 EST
At 08:15 PM 31/01/2004, JG wrote:
well, i did a thorough cable test with a DSP-4100 fluke networks cable
tester and i had some bad values. i've been using 3 cables (24m) with
adapters, all single cables were fine, so the adapters seemed to cause the
problem.
but i'm now using a longer x-over cable (30m) where i also get those speed
problems. it is a *bit* better, i get about 1-2MB/s in both directions,
but i'm also experiencing a very high error rate over the x-over
cable...(~40-50 errors per second)
if you get ANY errors, then its bad; even 1 error per second basically
means "one lost packet per second", which will severly limit your TCP
throughput.
one thing you may want to do to is drop the link to 100mbit/s rather than
gig-e; that will use less cable pairs and may avoid the problem.
100mbit/s without errors will likely be way way faster than 1000mbit/s with
50 errors/sec.
do you have this BACS software and is it possible to test the NIC itself
with it? maybe one of my NICs is causing this.
it seems there is only a Windows version of their diagnostics.
personally, i use IBM xSeries servers. their version of the BACS code is
at <http://www-306.ibm.com/pc/support/site.wss/document.do?lndocid=MIGR-43815>.
i've seen other servers (e.g. Compaq DL360?) that also use the BCM57xx;
their BACS tool is rebadged as being a HP tool.
cheers,
lincoln.
thx,
JG
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/