Re: [PATCH r8169] ethtool support and sane speed selection/detection

[Francois Romieu]

[Jeff Garzik added to the loop]
[If nobody disagrees, I'll remove l-k from the Cc: during the next round]

Andy Lutomirski <luto@xxxxxxxxxxxxx> :
> This adds ethtool support to r8169.

Cool.

> Some notes:  I stole the RxUnderrun interrupt status bit because (1) I
> don't know what a recieve underrun is, (2) the specs say that bit is
> actually "link status changed" and (3) simple tests seem to confirm that.

Ok, this bit is named 'LinkChg' in drivers/net/8139cp.c as well.

> Speed selection doesn't actually set a forced mode but just sets
> autonegotiation to advertise only one speed.  (This way there is no ugly
> special case for 1000Mbps.)
> 
> The link status is no longer checked on startup because it is slow and, with
> ethtool support, unnecessary.

Just to clarify, it is still done in rtl8169_open() instead of rtl8169_init_one().
Even if it is a change of behavior in a supposedly stable serie, I guess it is ok
as it moves the driver in the direction of the 8139cp driver.

> As an added benefit, my 8001S often fails to negotiate 1000Mbps when the
> driver loads but will successfully negotiate it after a while.  Running
> 'ethtool -s ethx autoneg on' fixes it, but that's absurd.  This patch
> will, ten seconds after the driver starts, check if 1000Mbps is advertised
> but not selected, and, if so, force a renegotiation.

So you can not reliably remove the phy timer and simply use the LinkChg status
change, right ?

Is everybody fine if I cook up a serie of patches for -netdev/-mm inclusion
which includes:
- your link related changes
- start of a 8139cp.c genetic mutation on top of those
- reworked Jon D Mason's NAPI changes

ETA: this week end, start of incoming week.

--
Ueimor
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/