Re: Promise 20269 (Rev 02) IDE controller

[Joel Cant]

Robert W. Fuller wrote:

> I probably have the same card.  This works perfectly in my box and I 
> do raw video capture with it (sustained 20+ MB/second.)  Thus, I 
> suspect the problem is specific to your system.  Here's my lspci -vv:
>
> 0000:00:0f.0 Unknown mass storage controller: Promise Technology, Inc. 
> 20269 (re
> v 02) (prog-if 85)
>         Subsystem: Promise Technology, Inc. Ultra133TX2
>         Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
> ParErr- Step
> ping- SERR- FastB2B-
>         Status: Cap+ 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- 
> <TAbort-
> <MAbort- >SERR- <PERR-
>         Latency: 32 (1000ns min, 4500ns max), cache line size 08
>         Interrupt: pin A routed to IRQ 19
>         Region 0: I/O ports at a800
>         Region 1: I/O ports at ac00 [size=4]
>         Region 2: I/O ports at b000 [size=8]
>         Region 3: I/O ports at b400 [size=4]
>         Region 4: I/O ports at b800 [size=16]
>         Region 5: Memory at e3000000 (32-bit, non-prefetchable) 
> [size=16K]
>         Capabilities: [60] Power Management version 1
>                 Flags: PMEClk- DSI+ D1+ D2- AuxCurrent=0mA 
> PME(D0-,D1-,D2-,D3hot
> -,D3cold-)
>                 Status: D0 PME-Enable- DSel=0 DScale=0 PME-

Hi,

Seems our cards are very similar, out of interest what kernel are you 
running, and whats your kernel .config, Would it be anything to do with 
running it in a pci-x slot, although that shouldent be an issue. What is 
the possiblity of a hardware fault, dont want to organise an RMA then 
them tell me its fine under winblows, is there anyway to spew out a bit 
more info on the error, or run a test on it?

Thanks

Joel

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/