Re: [PATCH] Re: APIC/LAPIC hanging problems on nForce2 system.

[Bartlomiej Zolnierkiewicz]

On Fri, 07 Jan 2005 14:53:42 +0100, Prakash K. Cheemplavam
<prakashkc@xxxxxx> wrote:
> Andrew Morton schrieb:
> > "Prakash K. Cheemplavam" <prakashkc@xxxxxx> wrote:
> >
> >>Perhaps firfox fscked up the inlined patch, so please
> >>try the attached version. If it goes alright, I'll resubmit it,
> >>inlcuding more detailed description.
> >
> >
> > There was no attachment.
> 
> *sigh* Not in my last email, but when I submitted the patch...
> 
> > Please go ahead and prepare a final patch against Linus's latest tree.  The
> > simplest way to obtain that is via the topmost link at
> > http://www.kernel.org/pub/linux/kernel/v2.5/testing/cset/.
> 
> It applies cleanly there. Nevertheless, once again, with more details.
> If inlined version doesn't patch, please try attached!
> 
> current state:
> Systems with Nforce2 could freeze on high disk i/o activity in APIC mode
> when CPU Disconnect is enabled. If bios doesn't fix this, current kernel
> fix changes the registers according to follwing table:
> 
>       * Chip  Old value   New value
>       * C17   0x1F0FFF01  0x1F01FF01
>       * C18D  0x9F0FFF01  0x9F01FF01
> 
> But this is only done, if cpu disconnect has been enabled in bios.
> 
> why change this:
> If CPU disconnect is not enabled in bios, and bios is broken (some
> manufacturers like Abit don't care about their customers and even the
> latest bios doesn't fix this; I have an Abit mainboard), the kernel
> doesn't apply the fix, so if cpu disconnect is enabled at a later stage
> (in userspace), the system will be unstable and most likely freeze.
> 
> new behaviour:
> The fix is now applied regardless of cpu disconnect being enabled at
> boot time, or not. As you only have to change byte 3 to 0x01, reading
> out chipset version isn't needed, so the patch simplifies the fix. Now
> turning cpu disconnect on, at later stage won't break the system, and if
> it was already enabled, it gets fixed, as the old version did.
> 
> 
> Signed-off-by: Prakash Punnoor <prakashp@xxxxxxxx>

Patch looks fine (thanks!) and since I added the original quirk...

Acked-by: Bartlomiej Zolnierkiewicz <bzolnier@xxxxxxxxx>

> --- arch/i386/pci/fixup.c.o     2005-01-06 15:43:40.535842320 +0100
> +++ arch/i386/pci/fixup.c       2005-01-06 16:00:50.174313480 +0100
> @@ -227,10 +227,7 @@
>    */
>   static void __init pci_fixup_nforce2(struct pci_dev *dev)
>   {
> -       u32 val, fixed_val;
> -       u8 rev;
> -
> -       pci_read_config_byte(dev, PCI_REVISION_ID, &rev);
> +       u32 val;
> 
>         /*
>          * Chip  Old value   New value
> @@ -240,17 +237,14 @@
>          * Northbridge chip version may be determined by
>          * reading the PCI revision ID (0xC1 or greater is C18D).
>          */
> -       fixed_val = rev < 0xC1 ? 0x1F01FF01 : 0x9F01FF01;
> -
>         pci_read_config_dword(dev, 0x6c, &val);
> 
>         /*
> -        * Apply fixup only if C1 Halt Disconnect is enabled
> -        * (bit28) because it is not supported on some boards.
> +        * Apply fixup if needed, but don't touch disconnect state
>          */
> -       if ((val & (1 << 28)) && val != fixed_val) {
> +       if ((val & 0x00FF0000) != 0x00010000) {
>                 printk(KERN_WARNING "PCI: nForce2 C1 Halt Disconnect fixup\n");
> -               pci_write_config_dword(dev, 0x6c, fixed_val);
> +               pci_write_config_dword(dev, 0x6c, (val & 0xFF00FFFF) | 0x00010000);
>         }
>   }
>   DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_NVIDIA,
> PCI_DEVICE_ID_NVIDIA_NFORCE2, pci_fixup_nforce2);
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/