Re: [RFC] Driver States

[Patrick Mochel]

On Sun, 27 Mar 2005, Adam Belay wrote:

> Dynamic power management may require devices and drivers to transition
> between various physical and logical states.  I would like to start a
> discussion on how these might be defined at the bus, driver, and class
> levels.

<snip>

> Bus Level
> =========
> At the bus level, there are two state attributes, power and
> enable/disable.  Enable/disable may mean different things on different
> buses, but they generally refer to resource decoding.  A device can only
> be enabled during a non-off power state.

<...>

> Driver Level
> ============
> At the driver level there are two areas of interest, physical and
> logical state.  There is an additional concern of transitioning between
> these states multiple times.  Because a driver acts as a bridge between
> physical and logical components, I think separating these steps seems
> natural.

<...>

> *attach - allocates data structures, creates sysfs entries, prepares driver
>        to handle the hardware.
>
> *start -  Sets up device resources and configures the hardware.  Loads
> firmware, etc.
> (physical)
>
> *open -   engages the hardware, and makes it usable by the class device.
> (logical and physical)
>
> *close -  disengages the hardware, and stops class level access
> (logical and physical)
>
> *stop -   physically disables the hardware
> (physical)
>
> *detach - tears down the driver and releases it from the "struct device"
>

You have a few things here that can easily conflict, and that will be
developed at different paces. I like the direction that it's going, but
how do you intend to do it gradually. I.e. what to do first?


	Pat

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/