Re: 2.6.13-mm1: hangs during boot ...

[Peter Williams]

Brown, Len wrote:
> > > [  279.662960]  [<c02d5c74>] wait_for_completion+0xa4/0x110
>
>
> possibly a missing interrupt?
>
>
> > CONFIG_ACPI=y
>
>
> any difference if booted with "acpi=off" or "acpi=noirq"?

Yes.  In both cases, the system appears to boot normally but I'm unable 
to login or connect via ssh.  Also there's a "device not ready" message 
after the scsi initialization which I don't normally see.  I've attached 
the scsi initialization output.  The PF_NETLINK error messages after the 
login prompt in this output are created whenever I try to log in or 
connect via ssh.

Peter
--
Peter Williams                                   pwil3058@xxxxxxxxxxxxxx

"Learning, n. The kind of ignorance distinguishing the studious."
 -- Ambrose Bierce
[    8.345086] SCSI subsystem initialized
[    8.427503] sym0: <810a> rev 0x23 at pci 0000:00:08.0 irq 16
[    8.504636] sym0: No NVRAM, ID 7, Fast-10, SE, parity checking
[    8.588216] sym0: SCSI BUS has been reset.
[    8.642194] scsi0 : sym-2.2.1
[   12.368622]   Vendor: PIONEER   Model: DVD-ROM DVD-303R  Rev: 2.00
[   12.450118]   Type:   CD-ROM                             ANSI SCSI revision:2[   12.546506]  target0:0:2: Beginning Domain Validation
[   12.613354]  target0:0:2: asynchronous.
[   12.667699]  target0:0:2: Domain Validation skipping write tests
[   12.747629]  target0:0:2: FAST-10 SCSI 10.0 MB/s ST (100 ns, offset 8)
[   12.837395]  target0:0:2: Ending Domain Validation
[   13.256875]   Vendor: SONY      Model: CD-RW  CRX140S    Rev: 1.0e
[   13.338323]   Type:   CD-ROM                             ANSI SCSI revision:4[   13.434891]  target0:0:4: Beginning Domain Validation
[   13.503101]  target0:0:4: asynchronous.
[   13.602931]  target0:0:4: Domain Validation skipping write tests
[   13.683605]  target0:0:4: FAST-10 SCSI 10.0 MB/s ST (100 ns, offset 8)
[   13.777934]  target0:0:4: Ending Domain Validation
[   14.884703] Device  not ready.
[   15.763312] kjournald starting.  Commit interval 5 seconds
[   15.835612] EXT3-fs: mounted filesystem with ordered data mode.


Fedora Core release 4 (Stentz)
Kernel 2.6.13-mm1 on an i686

origma.pw.nest login:

[  101.886572] DEBUG: Failed to load PF_NETLINK protocol 9
[  101.963572] DEBUG: Failed to load PF_NETLINK protocol 9