Re: [PATCH/2.6.17-rc4 10/10] bugs fix for marvell SATA on powerp c pl atform

[Sven Luther]

On Fri, May 26, 2006 at 04:56:00AM -0400, Jeff Garzik wrote:
> Sven Luther wrote:
> >On Thu, May 18, 2006 at 04:50:46PM -0400, Mark Lord wrote:
> >>Jeff Garzik wrote:
> >>>Benjamin Herrenschmidt wrote:
> >>>>On Thu, 2006-05-18 at 12:03 +0800, Zang Roy-r61911 wrote:
> >>..
> >>>>>@@ -1567,13 +1570,18 @@ static void mv5_read_preamp(struct mv_ho
> >>>>> static void mv5_enable_leds(struct mv_host_priv *hpriv, void __iomem
> >>>>*mmio)
> >>>>> {
> >>>>>      u32 tmp;
> >>>>>-
> >>>>>+#ifndef CONFIG_PPC
> >>>>>      writel(0, mmio + MV_GPIO_PORT_CTL);
> >>>>>+#endif
> >>>>You'll have to do better here too... I don't wee why when compiled on
> >>>>PPC, this driver should "magically" not clear those bits... At the very
> >>>>least, you should test the machine type if you want to do something
> >>>>specific to your platform, but first, you'll have to convince Jeff why
> >>>>this change has to be done in the first place and if there is a better
> >>>>way to handle it.
> >>>Correct...  it does seem some bugs were found, but #ifdef powerpc is 
> >>>certainly out of the question.  We want the driver to work without 
> >>>ifdefs on all platforms.
> >>Yup.  I have a powerpc platform here with PCI-X, and a PCI-X Marvell card
> >>to try in it.  So I'll pick up these changes and try to integrate them a
> >>little more nicely in my internal updated driver, and then pass it on to 
> >>Jeff.
> >
> >Hi, ...
> >
> >I am trying to use a Marvell 88SX5081 based card here in my pegasos 
> >machine,
> >and i never got it working with the libata driver, even with the patches 
> >Zang
> >provided (and 2.6.16 though, maybe i should update to a newer version). The
> >marvell provided driver worked though at some time.
> >
> >Would it be possible to have access to your work, in order to not duplicate
> >effort or something ? 
> 
> Do you have any debug output (see top of libata.h)?

Ah, not yet, but i can provide such.

Right now, i see the drive (with Zang's patch), but any attempt to access it
get me : 

ata1: status=0x50 {DriveReady SeekComplete }
ata1: error=0x01 {AddrMarkNotFound }
sata_mv: PCI ERROR; PCI IRQ cause=0x00000400
sda: Current: sensekey: No Sense
   Additional sense: No Additional sense information

The disk is a hitachi 80GB sata one.

I will compile a kernel with debug output and provide more info in a bit.

Friendly,

Sven Luther

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/