Re: [PATCH 1/2] [PCI] Check that MWI bit really did get set

[Andrew Morton]

On Fri, 06 Oct 2006 13:05:18 -0600
Matthew Wilcox <matthew@xxxxxx> wrote:

> Since some devices may not implement the MWI bit, we should check that
> the write did set it and return an error if it didn't.
> 
> Signed-off-by: Matthew Wilcox <matthew@xxxxxx>
> 
> diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c
> index a544997..3d041f4 100644
> --- a/drivers/pci/pci.c
> +++ b/drivers/pci/pci.c
> @@ -900,13 +900,17 @@ #endif
>  		return rc;
>  
>  	pci_read_config_word(dev, PCI_COMMAND, &cmd);
> -	if (! (cmd & PCI_COMMAND_INVALIDATE)) {
> -		pr_debug("PCI: Enabling Mem-Wr-Inval for device %s\n", pci_name(dev));
> -		cmd |= PCI_COMMAND_INVALIDATE;
> -		pci_write_config_word(dev, PCI_COMMAND, cmd);
> -	}
> -	
> -	return 0;
> +	if (cmd & PCI_COMMAND_INVALIDATE)
> +		return 0;
> +
> +	pr_debug("PCI: Enabling Mem-Wr-Inval for device %s\n", pci_name(dev));
> +	cmd |= PCI_COMMAND_INVALIDATE;
> +	pci_write_config_word(dev, PCI_COMMAND, cmd);
> +
> +	/* read result from hardware (in case bit refused to enable) */
> +	pci_read_config_word(dev, PCI_COMMAND, &cmd);
> +
> +	return (cmd & PCI_COMMAND_INVALIDATE) ? 0 : -EINVAL;
>  }
>  
>  /**

Bisection shows that this patch
(pci-check-that-mwi-bit-really-did-get-set.patch in Greg's PCI tree) breaks
suspend-to-disk on my Vaio.  It writes the suspend image and gets to the
point where it's supposed to power down, but doesn't.

After a manual power-cycle it successfully resumes from disk, but
networking (at least) is dead.

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/