Re: [PATCH 2.6.19-rc6] sata_promise updates

[Jeff Garzik]

Mikael Pettersson wrote:
> This patch updates the sata_promise driver as follows:
> - Correct typo in definition of PDC_TBG_MODE: it's at 0x41C not 0x41
>   in first-generation chips. This error caused PCI access alignment
>   exceptions on SPARC64, and on all platforms it disabled the expected
>   initialisation of TBG mode.
> - Prevent TBG mode and SLEW rate initialisation in second-generation chips.
>   These two registers have moved, TBG mode has been redefined, and
>   Promise's ulsata2 driver no longer attempts to initialise them.
> - Correct PCI device table so devices 0x3570, 0x3571, and 0x3d73 are
>   marked as 2057x (2nd gen) not 2037x (1st gen).
> - Correct PCI device table so device 0x3d17 is marked as 40518
>   (2nd gen 4 ports) not 20319 (1st gen 4 ports).
> - Correct pdc_ata_init_one() to treat 20771 as a second-generation chip.
>   (The 20771 classification is redundant as it is equivalent to 2057x.)
>
> Tested on 0x3d75 (2nd gen), 0x3d73 (2nd gen), and 0x3373 (1st gen) chips.
> The information comes from the newly uploaded Promise SATA HW specs,
> Promise's ultra and ulsata2 drivers, and debugging on 3d75/3d73/3373 chips.
>
> Signed-off-by: Mikael Pettersson <mikpe@xxxxxxxx>

Looks pretty decent to me.  Two small nits:

1) no_tbg_slew_init should be a bit flag ("1 << 0") inside a 'flags' 
variable in struct pdc_host_priv.

2) Check pdc_ulsata2 again, I think the flash control register is 
programmed with a different value on SATAI versus SATAII.

	Jeff


-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/