Natsemi DP83815 driver spaming

From: RafaÅ Bilski
Date: Mon Apr 30 2007 - 16:59:21 EST


I have Wyse 3360SE terminal running Linux 2.6.21-rc7. Everything
works great with one small exception. Natsemi DP83815 driver is
filling log with:
> ezri kernel: eth0: DSPCFG accepted after 0 usec.
> ezri user.notice kernel: eth0: Wake-up event 0x80000a
> ezri kernel: eth0: Setting full-duplex based on negotiated link capability.
every 5 seconds. I can comment out these messages, but I would
like to turn off the source of wake up event. It is a bit
strange to see wakeup event on running system.

Please CC me.

Thank You

natsemi dp8381x driver, version 2.1, Sept 11, 2006
originally by Donald Becker <becker@xxxxxxxxx>
2.4.x kernel port by Jeff Garzik, Tjeerd Mulder
PCI: Setting latency timer of device 0000:00:0f.0 to 64
natsemi eth0: NatSemi DP8381[56] at 0x10010000 (0000:00:0f.0), 00:80:64:10:c6:09, IRQ 10, port TP.

00:0f.0 Ethernet controller: National Semiconductor Corporation DP83815 (MacPhyter) Ethernet Controller
Subsystem: National Semiconductor Corporation DP83815 (MacPhyter) Ethernet Controller
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (2750ns min, 13000ns max)
Interrupt: pin A routed to IRQ 10
Region 0: I/O ports at f800 [size=256]
Region 1: Memory at 10010000 (32-bit, non-prefetchable) [size=4K]
[virtual] Expansion ROM at 10000000 [disabled] [size=64K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=320mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME+

...zanim nie porownasz cen >>

To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at
Please read the FAQ at