Re: sym53c8xx2: incredible sloth after parity error / SCSI busreset

[Andrew Morton]

On Sun, 02 Dec 2007 00:14:21 +0000
Nix <nix@xxxxxxxxxxxxx> wrote:

> About once a year I get a SCSI parity error on one of my systems (the
> only one with SCSI). I presume the cabling is substandard, but given my
> coordination deficits and the rarity of the errors I'd do far more
> damage replacing it than leaving it be.
> 
> I had one of these today.
> 
> The system (2.6.23.9) spotted the error, and seemingly recovered:
> 
> Dec  1 12:53:40 loki warning: kernel: sym0: SCSI parity error detected: SCR1=132 DBC=50000000 SBCL=0
> Dec  1 12:53:40 loki warning: kernel: sym0:0: ERROR (81:0) (8-0-0) (10/9d/0) @ (mem c2800048:ffffffff).
> Dec  1 12:53:40 loki warning: kernel: sym0: regdump: da 00 00 9d 47 10 00 0e 00 08 80 00 80 00 0f 0a d0 58 3c 01 02 ff ff ff.
> Dec  1 12:53:40 loki warning: kernel: sym0: SCSI BUS reset detected.
> Dec  1 12:53:40 loki notice: kernel: sym0: SCSI BUS has been reset.
> 
> However, after that reset I/O to any device on that controller is
> *incredibly* slow.
> 
> A monthly RAID check kicked off shortly afterwards and provided my first
> clue. Load average >15, and:
> 
> md1 : active raid5 sda6[0] hdc5[3] sdb6[1]
>       76807296 blocks super 1.2 level 5, 64k chunk, algorithm 2 [3/3] [UUU]
>       [========>............]  check = 42.8% (16450780/38403648) finish=253.3min speed=1442K/sec
> 
> 1442Kb/s is a bit less than I'd expect from a three-drive array with
> disks capable of 40Mb/s easily.
> 
> /dev/sda:
>  Timing buffered disk reads:    8 MB in  3.50 seconds =   2.29 MB/sec
> 
> A somewhat slower ATAPI disk on the same machine:
> 
> /dev/hdc:
>  Timing buffered disk reads:  110 MB in  3.05 seconds =  36.08 MB/sec
> 
> So, um, what could cause this? Can I speed it up again other than by
> rebooting (which I'm just about to do, but it is annoying).
> 

cc linux-scsi.

Nothing is likely to happen.  Please raise a report at bugzilla.kernel.org.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/