Hello, (can you CC me? i'm not on the list)
I have a LSI MegaRAID SAS 8204ELP card, and since it wasn't recognized by any driver, i tried using the megasr driver supplied by LSI (it also supplies open_source code with it), i had to modify the code a bit to get it to boot with kernel-2.6.21 . but there's a very high iowait on it. i'm wondering if the megaraid_sas driver is meant to be the driver for the same hardware as megasr? would it help if i just added another PCI ID to the module and try that one?
Sincerely,
Maarten Vanraes
[] # lspci -s 08:00.0 -vvvn
08:00.0 0100: 1000:0059 (rev 08)
Subsystem: 1000:3002
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr+ Stepping- SERR+ FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR+ <PERR- INTx-
Latency: 0, Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 18
Region 0: I/O ports at 3000 [size=256]
Region 1: Memory at d8410000 (64-bit, non-prefetchable) [size=16K]
Region 3: Memory at d8400000 (64-bit, non-prefetchable) [size=64K]
[virtual] Expansion ROM at d8000000 [disabled] [size=2M]
Capabilities: [50] Power Management version 2
Capabilities: [68] Express (v1) Endpoint, MSI 00
Capabilities: [98] Message Signalled Interrupts: Mask- 64bit+ Capabilities: [b0] MSI-X: Enable- Mask- TabSize=1
Capabilities: [100] Advanced Error Reporting <?>