rt2500pci: Failed to initialize hw. But works with ancient rt2500-1.1.0

[Stefan Bauer]

Hi,


I'm not able to load rt2500pci from 2.6.26-rc9 under Gentoo.
This card currently works under Debian Etch with 2.6.18 kernel and 
rt2500-source 1.1.0+cvs20060620-3.

lspci -vvvv
Network controller: RaLink RT2500 802.11g Cardbus/mini-PCI (rev 01)
Subsystem: RaLink Unknown device 2560
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- 
SERR+ FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- 
<MAbort- >SERR- <PERR-
Latency: 64, Cache Line Size: 64 bytes
Interrupt: pin A routed to IRQ 185
Region 0: Memory at fba00000 (32-bit, non-prefetchable) [size=8K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-

dmesg 2.6.18
PCI: Enabling device 0000:00:0c.0 (0110 -> 0112)
ACPI: PCI Interrupt 0000:00:0c.0[A] -> GSI 17 (level, low) -> IRQ 185
rt2500 1.1.0 CVS 2005/07/10 http://rt2x00.serialmonkey.com

dmesg 2.6.26-rc9
ACPI: PCI Interrupt 0000:00:0c.0[A] -> GSI 17 (level, low) -> IRQ 17
phy0: Selected rate control algorithm 'pid'
phy0: Failed to initialize wep
phy0 -> rt2x00lib_probe_dev: Error - Failed to initialize hw.
rt2500pci: probe of 0000:00:0c.0 failed with error -12

.config 2.6.18
precompiled Kernel from Debian

.config 2.6.26-rc9
<http://www-user.tu-chemnitz.de/~stefb/rt2500pci/config>

Next I'm going to test 2.6.24 and 2.6.25 to check whether it's an regression 
or not.


Regards,
Stefan
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/