[PATCH 09/21] amd64_edac: add k8-specific methods

[Borislav Petkov]

From: Doug Thompson <dougthompson@xxxxxxxxxxxx>

Signed-off-by: Doug Thompson <dougthompson@xxxxxxxxxxxx>
Signed-off-by: Borislav Petkov <borislav.petkov@xxxxxxx>
---
 drivers/edac/amd64_edac.c |  196 +++++++++++++++++++++++++++++++++++++++++++++
 1 files changed, 196 insertions(+), 0 deletions(-)

diff --git a/drivers/edac/amd64_edac.c b/drivers/edac/amd64_edac.c
index 9e11555..85ef6ad 100644
--- a/drivers/edac/amd64_edac.c
+++ b/drivers/edac/amd64_edac.c
@@ -2061,4 +2061,200 @@ static enum mem_type amd64_determine_memory_type(struct amd64_pvt *pvt)
 	return type;
 }
 
+/*
+ * k8_early_channel_count
+ *
+ *      NOTE: CPU Revision Dependent code
+ *
+ *      MUST read the hardware DCL register, and decode it, then return it
+ *
+ *      the DCL - DRAM Configuration Low Register contains various
+ *      configuration bits on memory.
+ *
+ *      BUT it is different between CG, D & E revs and the later
+ *      Rev F memory controllers (DDR vs DDR2)
+ *
+ * Return:
+ *      number of Memory Channels in operation
+ * Pass back:
+ *      contents of the DCL0_LOW register
+ */
+static int k8_early_channel_count(struct amd64_pvt *pvt)
+{
+	int flag;
+	int err;
+
+	err = pci_read_config_dword(pvt->dram_f2_ctl, F10_DCLR_0, &pvt->dclr0);
+	if (err != 0)
+		debugf0("%s() Reading F10_DCLR_0 failed\n", __func__);
+
+	if ((boot_cpu_data.x86_model >> 4) >= OPTERON_CPU_REV_F) {
+		/* Rev F (NPT) and later */
+		flag = pvt->dclr0 & F10_WIDTH_128;
+	} else {
+		/* Rev E and earlier */
+		flag = pvt->dclr0 & REVE_WIDTH_128;
+	}
+
+	/* not used */
+	pvt->dclr1 = 0;
+
+	return (flag) ? 2 : 1;
+}
+
+/*
+ * k8_get_error_address
+ *	extract from the hardware copies of the error register
+ *	the ERROR ADDRESS for the K8 and Family 0Fh CPUs
+ */
+static u64 k8_get_error_address(struct mem_ctl_info *mci,
+			struct amd64_error_info_regs *info)
+{
+	return (((u64) (info->nbeah & 0xff)) << 32) +
+			(info->nbeal & ~0x03);
+}
+
+/*
+ * k8_read_dram_base_limit
+ *
+ *	Read the Base and Limit registers for K8 based Memory controllers
+ *	Extract fields from the 'raw' reg into separate data fields
+ *
+ *		Isolates: BASE, LIMIT, IntlvEn, IntlvSel, RW_EN
+ */
+static void k8_read_dram_base_limit(struct amd64_pvt *pvt, int dram)
+{
+	u32 low;
+	u32 off = dram << 3;	/* 8 bytes between DRAM entries */
+	int err;
+
+	err = pci_read_config_dword(pvt->addr_f1_ctl,
+					K8_DRAM_BASE_LOW + off, &low);
+	if (err != 0)
+		debugf0("%s() Reading K8_DRAM_BASE_LOW failed\n", __func__);
+
+	/* Extract parts into separate data entries */
+	pvt->dram_base[dram] = ((u64) low & 0xFFFF0000) << 8;
+	pvt->dram_IntlvEn[dram] = (low >> 8) & 0x7;
+	pvt->dram_rw_en[dram] = (low & 0x3);
+
+	err = pci_read_config_dword(pvt->addr_f1_ctl, K8_DRAM_LIMIT_LOW + off,
+		&low);
+	if (err != 0)
+		debugf0("%s() Reading K8_DRAM_LIMIT_LOW failed\n", __func__);
+
+	/* Extract parts into separate data entries
+	 * Limit is the HIGHEST memory location of the region, so lower
+	 * 24-bit needs to be all ones
+	 */
+	pvt->dram_limit[dram] = (((u64) low & 0xFFFF0000) << 8) | 0x00FFFFFF;
+	pvt->dram_IntlvSel[dram] = (low >> 8) & 0x7;
+	pvt->dram_DstNode[dram] = (low & 0x7);
+}
+
+
+/*
+ * k8_map_sysaddr_to_csrow
+ *
+ *	map a SystemAddress to NodeID, CSROW, Channel
+ */
+static void k8_map_sysaddr_to_csrow(struct mem_ctl_info *mci,
+					struct amd64_error_info_regs *info,
+					u64 SystemAddress)
+{
+	struct mem_ctl_info *src_mci;
+	unsigned short syndrome;
+	int channel, csrow;
+	u32 page, offset;
+
+	/* Extract the syndrome parts and form a 16-bit syndrome */
+	syndrome = EXTRACT_HIGH_SYNDROME(info->nbsl) << 8;
+	syndrome |= EXTRACT_LOW_SYNDROME(info->nbsh);
+
+	/* CHIPKILL enabled */
+	if (info->nbcfg & K8_NBCFG_CHIPKILL) {
+		/* x4 chipkill ecc mode - determine channel */
+		channel = get_channel_from_x4_syndrome(syndrome);
+		if (channel < 0) {
+			/* Syndrome didn't map, so we don't know which of
+			 * the 2 DIMMs is in error. So we need to ID 'both'
+			 * of them as suspect.
+			 */
+			amd64_mc_printk(mci, KERN_WARNING,
+				     "unknown syndrome 0x%x - possible error "
+				     "reporting race\n", syndrome);
+			edac_mc_handle_ce_no_info(mci, EDAC_MOD_STR);
+			return;
+		}
+	} else {
+		/* non-chipkill ecc mode
+		 *
+		 * The k8 documentation is unclear about how to determine the
+		 * channel number when using non-chipkill memory.  This method
+		 * was obtained from email communication with someone at AMD.
+		 * (Wish the email was placed in this comment - norsk)
+		 */
+		channel = ((SystemAddress & BIT(3)) != 0);
+	}
+
+	/* Find out which node the error address belongs to.  This may be
+	 * different from the node that detected the error.
+	 */
+	src_mci = find_mc_by_sys_addr(mci, SystemAddress);
+	if (src_mci == NULL) {
+		amd64_mc_printk(mci, KERN_ERR,
+			     "failed to map error address 0x%lx to a node\n",
+			     (unsigned long)SystemAddress);
+		edac_mc_handle_ce_no_info(mci, EDAC_MOD_STR);
+		return;
+	}
+
+	/* Now map the SystemAddress to a CSROW */
+	csrow = sys_addr_to_csrow(src_mci, SystemAddress);
+	if (csrow < 0) {
+		edac_mc_handle_ce_no_info(src_mci, EDAC_MOD_STR);
+	} else {
+		error_address_to_page_and_offset(SystemAddress, &page, &offset);
+
+		edac_mc_handle_ce(src_mci, page, offset, syndrome, csrow,
+				  channel, EDAC_MOD_STR);
+	}
+}
+
+/*
+ * k8_dbam_map_to_pages
+ *
+ *	determrine the number of PAGES in for this DIMM's size
+ *	based on its DRAM Address Mapping.
+ */
+static int k8_dbam_map_to_pages(struct amd64_pvt *pvt, int dram_map)
+{
+	int nr_pages;
+
+	/* First step is to calc the number of bits to shift a value of 1
+	 * left to indicate show many pages. Start with the DBAM value
+	 * as the starting bits, then proceed to adjust those shift
+	 * bits, based on CPU REV and the table. See BKDG on the DBAM
+	 */
+	if (pvt->ext_model >= OPTERON_CPU_REV_F) {
+
+		/* REV F and greater section */
+		nr_pages = 1 << (revf_quad_ddr2_shift[dram_map] - PAGE_SHIFT);
+	} else {
+		/* REV E and less section This line is tricky.
+		 * It collapses the table used by revision D and later to one
+		 * that matches revision CG and earlier
+		 */
+		dram_map -= (pvt->ext_model >= OPTERON_CPU_REV_D) ?
+				(dram_map > 8 ? 4 : (dram_map > 5 ?
+				3 : (dram_map > 2 ? 1 : 0))) : 0;
+
+		/* 25 shift, is 32MiB minimum DIMM size in REV E and prior
+		 */
+		nr_pages = 1 << (dram_map + 25 - PAGE_SHIFT);
+	}
+
+	return nr_pages;
+}
+
 
-- 
1.6.2.4


--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/