[PATCH v5] enable x2APIC without interrupt remapping under KVM

[Gleb Natapov]

KVM would like to provide x2APIC interface to a guest without emulating
interrupt remapping device. The reason KVM prefers guest to use x2APIC
is that x2APIC interface is better virtualizable and provides better
performance than mmio xAPIC interface:
    
- msr exits are faster than mmio (no page table walk, emulation)
- no need to read back ICR to look at the busy bit
- one 64 bit ICR write instead of two 32 bit writes
- shared code with the Hyper-V paravirt interface
    
Included patch changes x2APIC enabling logic to enable it even if IR
initialization failed, but kernel runs under KVM and no apic id is
greater than 255 (if there is one spec requires BIOS to move to x2apic
mode before starting an OS).

Signed-off-by: Gleb Natapov <gleb@xxxxxxxxxx>
---

This version does not rely on x2apic_preenabled to determine max APIC id
since this logic will break after kexec. Use max_physical_apicid instead.
Also allow to override apic ops after call to enable_IR_x2apic() since
we may decide to use physical mode instead of cluster.

diff --git a/arch/x86/kernel/apic/apic.c b/arch/x86/kernel/apic/apic.c
index 8c7c042..db0c07f 100644
--- a/arch/x86/kernel/apic/apic.c
+++ b/arch/x86/kernel/apic/apic.c
@@ -49,6 +49,7 @@
 #include <asm/mtrr.h>
 #include <asm/smp.h>
 #include <asm/mce.h>
+#include <asm/kvm_para.h>
 
 unsigned int num_processors;
 
@@ -1363,52 +1364,74 @@ void enable_x2apic(void)
 }
 #endif /* CONFIG_X86_X2APIC */
 
-void __init enable_IR_x2apic(void)
+int __init enable_IR(void)
 {
 #ifdef CONFIG_INTR_REMAP
 	int ret;
-	unsigned long flags;
-	struct IO_APIC_route_entry **ioapic_entries = NULL;
 
 	ret = dmar_table_init();
 	if (ret) {
 		pr_debug("dmar_table_init() failed with %d:\n", ret);
-		goto ir_failed;
+		return 0;
 	}
 
 	if (!intr_remapping_supported()) {
 		pr_debug("intr-remapping not supported\n");
-		goto ir_failed;
+		return 0;
 	}
 
-
 	if (!x2apic_preenabled && skip_ioapic_setup) {
 		pr_info("Skipped enabling intr-remap because of skipping "
 			"io-apic setup\n");
-		return;
+		return 0;
 	}
 
+	if (enable_intr_remapping(x2apic_supported()))
+		return 0;
+
+	pr_info("Enabled Interrupt-remapping\n");
+
+	return 1;
+
+#endif
+	return 0;
+}
+
+void __init enable_IR_x2apic(void)
+{
+	unsigned long flags;
+	struct IO_APIC_route_entry **ioapic_entries = NULL;
+	int ret, x2apic_enabled = 0;
+
 	ioapic_entries = alloc_ioapic_entries();
 	if (!ioapic_entries) {
-		pr_info("Allocate ioapic_entries failed: %d\n", ret);
-		goto end;
+		 pr_info("Allocate ioapic_entries failed\n");
+		 goto out;
 	}
 
 	ret = save_IO_APIC_setup(ioapic_entries);
 	if (ret) {
 		pr_info("Saving IO-APIC state failed: %d\n", ret);
-		goto end;
+		goto out;
 	}
 
 	local_irq_save(flags);
-	mask_IO_APIC_setup(ioapic_entries);
 	mask_8259A();
+	mask_IO_APIC_setup(ioapic_entries);
 
-	ret = enable_intr_remapping(x2apic_supported());
-	if (ret)
-		goto end_restore;
+	ret = enable_IR();
+	if (!ret) {
+		/* IR is required if x2apic is enabled by BIOS even
+		 * when running in kvm since this indicates present
+		 * of APIC ID > 255 */
+	       	if (max_physical_apicid > 255 || !kvm_para_available())
+			goto nox2apic;
+		/* without IR all CPUs can be addressed by IOAPIC/MSI
+		 * only in physical mode */
+		x2apic_phys = 1;
+	}
 
-	pr_info("Enabled Interrupt-remapping\n");
+	x2apic_enabled = 1;
 
 	if (x2apic_supported() && !x2apic_mode) {
 		x2apic_mode = 1;
@@ -1416,41 +1439,30 @@ void __init enable_IR_x2apic(void)
 		pr_info("Enabled x2apic\n");
 	}
 
-end_restore:
-	if (ret)
-		/*
-		 * IR enabling failed
-		 */
+nox2apic:
+	if (!ret) /* IR enabling failed */
 		restore_IO_APIC_setup(ioapic_entries);
-
 	unmask_8259A();
 	local_irq_restore(flags);
 
-end:
+out:
 	if (ioapic_entries)
 		free_ioapic_entries(ioapic_entries);
 
-	if (!ret)
+	if (x2apic_enabled)
 		return;
 
-ir_failed:
-	if (x2apic_preenabled)
+	if (x2apic_preenabled) {
+#ifdef CONFIG_INTR_REMAP
 		panic("x2apic enabled by bios. But IR enabling failed");
-	else if (cpu_has_x2apic)
-		pr_info("Not enabling x2apic,Intr-remapping\n");
 #else
-	if (!cpu_has_x2apic)
-		return;
-
-	if (x2apic_preenabled)
 		panic("x2apic enabled prior OS handover,"
-		      " enable CONFIG_X86_X2APIC, CONFIG_INTR_REMAP");
+				" enable CONFIG_X86_X2APIC, CONFIG_INTR_REMAP");
 #endif
-
-	return;
+	} else if (cpu_has_x2apic)
+		pr_info("Not enabling x2apic,Intr-remapping\n");
 }
 
-
 #ifdef CONFIG_X86_64
 /*
  * Detect and enable local APICs on non-SMP boards.
diff --git a/arch/x86/kernel/apic/probe_64.c b/arch/x86/kernel/apic/probe_64.c
index bc3e880..f3b1037 100644
--- a/arch/x86/kernel/apic/probe_64.c
+++ b/arch/x86/kernel/apic/probe_64.c
@@ -50,11 +50,11 @@ static struct apic *apic_probe[] __initdata = {
 void __init default_setup_apic_routing(void)
 {
 #ifdef CONFIG_X86_X2APIC
-	if (x2apic_mode && (apic != &apic_x2apic_phys &&
+	if (x2apic_mode
 #ifdef CONFIG_X86_UV
-		       apic != &apic_x2apic_uv_x &&
+		       && apic != &apic_x2apic_uv_x
 #endif
-		       apic != &apic_x2apic_cluster)) {
+		       ) {
 		if (x2apic_phys)
 			apic = &apic_x2apic_phys;
 		else
--
			Gleb.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/