[PATCH 4/4] documentation

[Nitin Gupta]

Short guide on how to setup and use ramzswap.

Signed-off-by: Nitin Gupta <ngupta@xxxxxxxxxx>
---

 Documentation/blockdev/00-INDEX     |    2 +
 Documentation/blockdev/ramzswap.txt |   50 +++++++++++++++++++++++++++++++++++
 2 files changed, 52 insertions(+), 0 deletions(-)

diff --git a/Documentation/blockdev/00-INDEX b/Documentation/blockdev/00-INDEX
index c08df56..c1cb074 100644
--- a/Documentation/blockdev/00-INDEX
+++ b/Documentation/blockdev/00-INDEX
@@ -16,3 +16,5 @@ paride.txt
 	- information about the parallel port IDE subsystem.
 ramdisk.txt
 	- short guide on how to set up and use the RAM disk.
+ramzswap.txt
+	- short guide on how to setup compressed in-memory swap device.
diff --git a/Documentation/blockdev/ramzswap.txt b/Documentation/blockdev/ramzswap.txt
new file mode 100644
index 0000000..b026715
--- /dev/null
+++ b/Documentation/blockdev/ramzswap.txt
@@ -0,0 +1,50 @@
+ramzswap: Compressed RAM based swap device
+-------------------------------------------
+
+Project home: http://compcache.googlecode.com/
+
+* Introduction
+
+It creates RAM based block devices which can be used (only) as swap disks.
+Pages swapped to these devices are compressed and stored in memory itself.
+See project home for use cases, performance numbers and a lot more.
+
+The configuration parameters for individual ramzswap devices are set using
+rzscontrol userspace utility as shown below.
+
+* Usage
+
+Following shows a typical sequence of steps for using ramzswap.
+
+1) Load Modules:
+	modprobe ramzswap NUM_DEVICES=4
+	This creates 4 (uninitialized) devices: /dev/ramzswap{0,1,2,3}
+	(NUM_DEVICES parameter is optional. Default: 1)
+
+2) Initialize:
+	Use rzscontrol utility to configure and initialize individual
+	ramzswap devices. Example:
+	rzscontrol /dev/ramzswap2 --init # uses default value of disksize_kb
+
+	*See rzscontrol manpage for more details and examples*
+
+3) Activate:
+	swapon /dev/ramzswap2 # or any other initialized ramzswap device
+
+4) Stats:
+	rzscontrol /dev/ramzswap2 --stats
+
+5) Deactivate:
+	swapoff /dev/ramzswap2
+
+6) Reset:
+	rzscontrol /dev/ramzswap2 --reset
+	(This frees all the memory allocated for this device).
+
+
+Please report any problems at:
+ - Mailing list: linux-mm-cc at laptop dot org
+ - Issue tracker: http://code.google.com/p/compcache/issues/list
+
+Nitin Gupta
+ngupta@xxxxxxxxxx
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/