Kenji Kaneshige wrote:Yinghai Lu wrote:Kenji Kaneshige wrote:I confirmed system boot up without errors by "pci=try=1".My system doesn't boot (hangup) with the following error messagesthanks, at the same time please try "debug pci=try=1"
from Fusion MPT SAS driver. Those are different from the one
captured with the previous version of your patches.
Fusion MPT SAS Host driver 3.04.12
mptsas 0000:09:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18
mptbase: ioc0: Initiating bringup
mptbase: ioc0: WARNING - Unexpected doorbell active!
mptbase: ioc0: ERROR - Failed to come READY after reset!
IocState=f0000000
mptbase: ioc0: WARNING - ResetHistory bit failed to clear!
mptbase: ioc0: ERROR - Diagnostic reset FAILED! (ffffffffh)
mptbase: ioc0: WARNING - NOT READY WARNING!
mptbase: ioc0: ERROR - didn't initialize properly! (-1)
mptsas: probe of 0000:09:00.0 failed with error -1
mptsas 0000:0a:00.0: PCI INT A -> GSI 19 (level, low) -> IRQ 19
mptbase: ioc1: Initiating bringup
mptbase: ioc1: WARNING - Unexpected doorbell active!
mptbase: ioc1: ERROR - Failed to come READY after reset!
IocState=f0000000
mptbase: ioc1: WARNING - ResetHistory bit failed to clear!
mptbase: ioc1: ERROR - Diagnostic reset FAILED! (ffffffffh)
mptbase: ioc1: WARNING - NOT READY WARNING!
mptbase: ioc1: ERROR - didn't initialize properly! (-1)
mptsas: probe of 0000:0a:00.0 failed with error -1
I'll send the whole boot log privately.
I'll capture the bootlog with "debug" option and send it
to you soon.
Please also try "debug pci=try=7"
it should work too.