Re: Marvell eSATA - 88SE6121 on Asus M3A79-T Deluxe - not in AHCI

[Phil Turmel]

Hi Phil,

It seems no one noticed your question.  I've CC'd linux-scsi, in case the
experts have additional/better advice.

On 05/09/2010 10:13 AM, Phil Reynolds wrote:
> I have recently had cause to start using the eSATA port on my
> motherboard, an Asus M3A79-T Deluxe, but have found that it is not in
> AHCI mode and therefore not hotplug capable. There are no settings for
> the Marvell 88SE6121 controller available, other than simply whether it
> is enabled or not.
> 
> I gather from reading elsewhere that the kernel can put this controller
> into AHCI - I found a patch but found it was already present in the
> kernel in Debian lenny's backports. It is their version 2.6.32-bpo.3 -
> not entirely sure which exact source version this is built from.
> However, this patch does not work on this motherboard - either that or I
> have to make it active somehow, and the method of doing so is not obvious.
[snip /]

I have a similar chipset in my office server: 88SE6145.  If yours can run
in AHCI mode, you just need "ahci.marvell_enable=1" on your kernel command
line, or "options ahci marvell_enable=1" in your modprobe.conf.  (I have
ahci built-in, and no initramfs, so I put the option in my grub.conf.)

My Marvell chipset has both SATA and PATA ports... the PATA ports are
non-functional when the ahci driver runs the chipset.  Your mileage may
vary.

HTH,

Phil Turmel
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/