Re: [PATCH RT] ehea: make receive irq handler non-threaded(IRQF_NODELAY)

[Thomas Gleixner]

On Thu, 20 May 2010, Michael Ellerman wrote:
> On Wed, 2010-05-19 at 16:38 +0200, Thomas Gleixner wrote:
> > On Wed, 19 May 2010, Darren Hart wrote:
> > 
> > > On 05/18/2010 06:25 PM, Michael Ellerman wrote:
> > > > On Tue, 2010-05-18 at 15:22 -0700, Darren Hart wrote:
> 
> > > > The result of the discussion about two years ago on this was that we
> > > > needed a custom flow handler for XICS on RT.
> > > 
> > > I'm still not clear on why the ultimate solution wasn't to have XICS report
> > > edge triggered as edge triggered. Probably some complexity of the entire power
> > > stack that I am ignorant of.
> > > 
> > > > Apart from the issue of loosing interrupts there is also the fact that
> > > > masking on the XICS requires an RTAS call which takes a global lock.
> > 
> > Right, I'd love to avoid that but with real level interrupts we'd run
> > into an interrupt storm. Though another solution would be to issue the
> > EOI after the threaded handler finished, that'd work as well, but
> > needs testing.
> 
> Yeah I think that was the idea for the custom flow handler. We'd reset
> the processor priority so we can take other interrupts (which the EOI
> usually does for you), then do the actual EOI after the handler
> finished.

That only works when the card does not issue new interrupts until the
EOI happens. If the EOI is only relevant for the interrupt controller,
then you are going to lose any edge which comes in before the EOI as
well.

Thanks,

	tglx

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/