Re: pxa300 - DDRAM base value

[Eric Miao]

On Sun, Jun 6, 2010 at 1:19 AM, Marek Vasut <marek.vasut@xxxxxxxxx> wrote:
> Dne Ãt 1. Äervna 2010 07:44:18 balakrishnan napsal(a):
>> I am working on pxa300 based development board and using Linux 2.6.34.
>> This Linux kernel already has support for following boards
>> 1. zylonite_pxa300
>> 2. cm-x300
>> 3. colibri-pxa300
>> 4. littleton
>>
>> My doubt is that pxa300 based boards are using "0xa0000000" Âas DDRAM
>> base and PHYS_OFFSET is also defined in
>> "arch/arm/mach-pxa/include/mach/memory.h" as 0xa0000000.
>> But in our board ÂDDR is mapped in 0x80000000. Does it make any
>> problem?. Because after mmu is turned ON, my board is hanging.
>>
>> "zreladdr-y  := 0x80008000" is defined in
>> "arch/arm/mach-pxa/Makefile.boot" file .
>> my machine_desc is as follows
>> .phys_io    Â= 0x40000000,
>> .io_pg_offst  Â= (io_p2v(0x40000000) >> 18) & 0xfffc,
>> .boot_params  Â= 0x80000100,
>>
>
> Try editing both arch/arm/mach-pxa/Makefile.boot and
> arch/arm/mach/pxa/include/mach/memory.h
>
>> With Thanks
>> J.Balakrishnan
>
> The 0x80000000 should be aliased to 0xa0000000, but looking into the PXA docs,
> it is only on pxa320. Eric, any ideas on this ?
>

Should be working on pxa300/310 as well. If it doesn't, check you bootloader
to make sure the mapping is OK, and memory doesn't exceed
(0xa000_0000 - 0x8000_0000).
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/