Re: [PATCH v2 2/2] ux500: add ab8500-regulators machine specificdata

[Mark Brown]

On Wed, Jul 14, 2010 at 11:06:51PM +0530, Sundar R IYER wrote:

> > OK, but your current set of supplies is *very* suspect since you're
> > offering all this control to lists of consumers that don't exist, and

> As said, dont exist for *now*.

This comes back to my point about the control only making sense when the
consumers are present - if you've got missing or partial consumer setup
done then control is questionable.

> Probably, I should remove the REGULATOR_CHANGE_VOLTAGE flag for the fixed
> supplies (as in the driver) to clear up any confusing link. Should I?

Yes.

> > This is normal, but for fairly obvious reasons the very lowest power
> > states are generally handled outside of the regulator API at a hardware
> > level via hardware signals to the regulator.  It's not normally part of
> > the runtime constraints for use while the CPU is live.

> Yes. But my point was that even at a lower level than kernel (BIOS/firmware?)
> the switching would happen via SW. Please correct me if I am wrong!

Well, ultimately it's always triggered by software but the actual signal
to the regulator is often a logic level output by the SoC as the
processor enters a low power state rather than an I2C/SPI write.

> > I'm not sure how you expect this to actually work in practice?  It's
> > going to be pretty hard for a driver to do anything constructive if the
> > power to the hardware gets cut, for example.  Unless you can guarantee
> > that there will never be any use of the hardware without a driver with
> > regulator support one driver's idea of optimal may not join up with what
> > the other consumers need at all.

> Very true. But, I think this will *enforce* drivers using/sharing
> regulators to adhere to the framework to avoid surprises and sole-owner
> misuses, which is good, now that the AB8500 regulators *are* supported.

If you think your users will be sympathetic to this approach then I
guess...  obviously, it does have the potential to go rather badly wrong
especially if there are some drivers without regulator support out
there.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/