Re: [PATCH 6/9] scsi: megaraid_sas - Add the online reset to iMRchip

From: Tomas Henzl
Date: Tue Nov 30 2010 - 10:36:17 EST


On 11/19/2010 06:29 PM, Yang, Bo wrote:
> Driver added the OCR (online controller reset) support to megaraid sas iMR chip.
>
> Signed-off-by Bo Yang<bo.yang@xxxxxxx>
>
> ---
> drivers/scsi/megaraid/megaraid_sas.c | 74 ++++++++++++++++++++---------------
> drivers/scsi/megaraid/megaraid_sas.h | 5 +-
> 2 files changed, 47 insertions(+), 32 deletions(-)
>
> @@ -497,6 +503,8 @@ static int megasas_clear_intr_skinny(struct
> megasas_register_set __iomem *regs) { u32 status; + u32 mfiStatus = 0;
> + /* * Check if it is our interrupt */ @@ -507,6 +515,15 @@
> megasas_clear_intr_skinny(struct megasas } /* + * Check if it is our
> interrupt + */ + if ((megasas_read_fw_status_reg_gen2( regs) &
> MFI_STATE_MASK ) == + MFI_STATE_FAULT ) { + mfiStatus |=
> MFI_INTR_FLAG_FIRMWARE_STATE_CHANGE; + } else + mfiStatus |=
> MFI_INTR_FLAG_REPLY_MESSAGE; + + /* * Clear the interrupt by writing
> back the same value */ writel(status, &regs->outbound_intr_status);
In the hunk above you use the '|=' which is not needed, a simple
assignment is more readable, see below.

Tomas

@@ -493,6 +499,8 @@ static int
megasas_clear_intr_skinny(struct megasas_register_set __iomem *regs)
{
u32 status;
+ u32 mfiStatus;
+
/*
* Check if it is our interrupt
*/
@@ -503,6 +511,15 @@ megasas_clear_intr_skinny(struct megasas_register_set __iomem *regs)
}

/*
+ * Check if it is our interrupt
+ */
+ if ((megasas_read_fw_status_reg_gen2( regs) & MFI_STATE_MASK) ==
+ MFI_STATE_FAULT)
+ mfiStatus = MFI_INTR_FLAG_FIRMWARE_STATE_CHANGE;
+ else
+ mfiStatus = MFI_INTR_FLAG_REPLY_MESSAGE;
+
+ /*
* Clear the interrupt by writing back the same value
*/
writel(status, &regs->outbound_intr_status);


--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/