Re: [RFC] PM / Runtime: decrease verbosity in kernel log

[Rafael J. Wysocki]

On Monday, September 19, 2011, Vincent Palatin wrote:
> On Sat, Sep 17, 2011 at 09:23, Alan Stern <stern@xxxxxxxxxxxxxxxxxxx> wrote:
> > On Fri, 16 Sep 2011, Vincent Palatin wrote:
> >
> >> When activating the PCI runtime PM on a laptop, my kernel log is filled with
> >> messages such as the following ones and can be hardly read to find interesting
> >> information:
> >> ehci_hcd 0000:00:1d.7: PME# disabled
> >> ehci_hcd 0000:00:1d.7: PCI INT A -> GSI 16 (level, low) -> IRQ 16
> >> ehci_hcd 0000:00:1d.7: setting latency timer to 64
> >> ehci_hcd 0000:00:1d.7: PCI INT A disabled
> >> ehci_hcd 0000:00:1d.7: PME# enabled
> >> ehci_hcd 0000:00:1d.7: BAR 0: set to [mem 0x92205000-0x922053ff] (PCI address [0x92205000-0x922053ff])
> >> ehci_hcd 0000:00:1d.7: restoring config space at offset 0xf (was 0x100, writing 0x10b)
> >> ehci_hcd 0000:00:1d.7: restoring config space at offset 0x1 (was 0x2900000, writing 0x2900002)
> > ...
> >
> >> All those messages are triggered by the following cause, the laptop has a USB
> >> 3G modem with USB autosuspend activated. The USB device will wake up about
> >> every 30s to do some network related activities. Every time, the modem wakes
> >> up this triggers the wake up of the attached EHCI/PCI USB host controller
> >> which reconfigures its PCI interface, then everything go back to a suspended mode.
> >>
> >> Having the same 10 lines of log repeated is not really useful, but I probably
> >> cannot totally remove them since there are somewhat useful for PCI hotplug
> >> users and other PCI debugging.
> >> So, my proposal is to create a new dev_printk macro : "dev_printk_norpm" which
> >> outputs traces only when the device has not the runtime PM activated,
> >> and guard those traces with it.
> >> (cf the 2 patches in this thread as a PoC)
> >
> > Wouldn't it be easier just to change the existing messages to DEBUG
> > level?  Or are they more important than that?
> 
> Yes, I can simply replace all those printk by dev_dbg traces. For my
> use case, it's perfect.
> My main concern was people using PCI hotplug, I think, then, their log
> will remain mostly silent when inserting a card, I don't know if this
> is acceptable or not.

I think they don't really need that information except for debugging, right?

Rafael
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/