AW: [PATCH v10 3/4] drivers/i2c/busses/i2c-at91.c: add new driver

[Carsten Behling]

Hi Niko,

you a right. Driver works with that patch.

Mit freundlichen Grüßen / Best regards
Carsten Behling

Development Engineer
Garz & Fricke GmbH
Tempowerkring 2, 21079 Hamburg - Germany
Amtsgericht Hamburg HRB 60514
Geschäftsführer: Manfred Garz, Matthias Fricke
Phone: +49 (0) 40 791 899 - 56
Fax:    +49 40 / 791 899 - 39
www.garz-fricke.com 

 


-----Ursprüngliche Nachricht-----
Von: Voss, Nikolaus [mailto:N.Voss@xxxxxxxxxxx] 
Gesendet: Freitag, 27. April 2012 10:05
An: Carsten Behling
Cc: Marc-Oliver Westerburg; 'devel@xxxxxxxxxx'; 'Wolfram Sang'; 'linux-arm-kernel@xxxxxxxxxxxxxxxxxxx'; 'linux-kernel@xxxxxxxxxxxxxxx'; 'linux-i2c@xxxxxxxxxxxxxxx'; 'Hubert Feurstein'
Betreff: RE: [PATCH v10 3/4] drivers/i2c/busses/i2c-at91.c: add new driver

Hi Carsten,

Carsten Behling wrote on 2012-04-27:
>>  	INIT_COMPLETION(dev->cmd_complete);
>> +	dev->transfer_status = 0;
>>  	if (dev->msg->flags & I2C_M_RD) {
>>  		unsigned start_flags = AT91_TWI_START;
> 
> this patch will not work, because you reset 'dev->transfer_status'
> before it is evaluated on errors (AT91_TWI_NACK, AT91_TWI_OVRE). 

it should, because transfer_status is updated by the ISR between
wait_for_completion_interruptible_timeout() and the error evaluation.
Please try it out.

> > P.S. Are you using a RM9200? Seems that this SOC has some problems...
> 
> Yes, our ECO920 uses the RM9200, but we support it with an very old kernel
> (2.6.21). I remember there were many problems with I2C.

Ok, but good to hear the driver basically works with the RM9200.

Niko

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/