RE: [PATCH] bnx2: turn off the network statck during initialization

From: Jiang Wang
Date: Thu Aug 16 2012 - 17:48:04 EST



On Thu, 2012-08-16 at 20:28 +0000, Jiang Wang wrote:
> Also, I have another comment related to link state.
>
> Right now, the bnx2 driver powers up the device in bnx2_init_board(),
> regardless the netif_carrier is on or off.

We actually don't power up the device. bnx2_init_board() just probes the device. If link is already up, it will stay up. If it is down, it will stay down.

---- I see. I was confused by the name of bnx2_set_power_state() and I think the PHY is actually powered up by bnx2_reset_nic, right?

> This may introduce following inconsistent behaviors:
> 1) suppose the cable is plugged in to the NIC and the other end is
> connected to a switch
> 2) user powers up the box

The link may already be up before or when you power up the box because of management firmware (iLO, etc) or WoL.

---- OK.

> 3) the Linux does not bring up the interface; i.e, ifconfig ethx shows
> it is down
> 4) ethtool ethx will show no link
> 5) if the user goes to check the light on the physical NIC, he will
> see the green link light is ON. That means the link is up, right?
>
> I think it is better to power down the device until bnx2_open is
> called. In this way, ethtool report and the physical link light will
> be consistent.

We cannot power it down. If link is up, it is up for a reason (e.g. it is an iLO port, etc).

---- OK.


Thanks.


--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/