Re: [PATCH v6 1/4] Runtime Interpreted Power Sequences

From: Sascha Hauer
Date: Thu Sep 13 2012 - 03:18:39 EST


On Thu, Sep 13, 2012 at 10:03:27AM +0300, Tomi Valkeinen wrote:
> On Thu, 2012-09-13 at 09:00 +0200, Sascha Hauer wrote:
> > On Thu, Sep 13, 2012 at 09:54:09AM +0300, Tomi Valkeinen wrote:
> > > On Thu, 2012-09-13 at 15:36 +0900, Alex Courbot wrote:
> > > > On Thursday 13 September 2012 14:22:57 Tomi Valkeinen wrote:
> > > >
> > > > > However, I fear these board specific things may be quite a bit anything,
> > > > > so it may well be pwm, gpios and regulators are not enough for them. For
> > > > > example, there could be an FPGA on the board which requires some
> > > > > configuration to accomplish the task at hand. It could be rather
> > > > > difficult to handle it with a generic power sequence.
> > > >
> > > > Right. Note that this framework is supposed to be extended - I would like to
> > > > at least add regulator voltage setting, and maybe even support for clocks and
> > > > pinmux (but that might be out of place).
> > >
> > > Yes, that's one concern of mine... I already can imagine someone
> > > suggesting adding conditionals to the power sequence data. Perhaps also
> > > direct memory read/writes so you can twiddle registers directly.

These memory writes can be avoided when these registers are abstracted
as a regular gpio/regulator/pwm driver.

> > > And so
> > > on. Where's the limit what it should contain? Can we soon write full
> > > drivers with the DT data? =)
> >
> > I have this concern aswell, that's why I'm sceptical about this patch
> > set. But what are the alternatives? Adding power code to the drivers and
> > thus adding board specific code to them is backwards.
>
> As was pointed out in earlier posts in this thread, these are almost
> always device specific, not board specific.
>
> Do you have examples of board specific power sequences or such?

Sure, tons of. One board needs a gpio to be set high to enable backlight,
the next one to low, a regulator has to be enabled, and to avoid
flickering a certain timing has to be ensured. This is all highly board
specific.

Sascha

--
Pengutronix e.K. | |
Industrial Linux Solutions | http://www.pengutronix.de/ |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/