Re: [PATCH RFC v2] media: OF: add sync-on-green endpoint property

[Prabhakar Lad]

Hi Sylwester,

On Fri, May 24, 2013 at 4:41 PM, Sylwester Nawrocki
<sylvester.nawrocki@xxxxxxxxx> wrote:
> Prabhakar,
>
>
> On 05/16/2013 03:18 PM, Lad Prabhakar wrote:
>>
>> From: Lad, Prabhakar <prabhakar.csengg@xxxxxxxxx>
>>
>> This patch adds "sync-on-green" property as part of
>> endpoint properties and also support to parse them in the parser.
>
>
>> --- a/Documentation/devicetree/bindings/media/video-interfaces.txt
>> +++ b/Documentation/devicetree/bindings/media/video-interfaces.txt
>> @@ -101,6 +101,8 @@ Optional endpoint properties
>>     array contains only one entry.
>>   - clock-noncontinuous: a boolean property to allow MIPI CSI-2
>> non-continuous
>>     clock mode.
>> +-sync-on-green: a boolean property indicating to sync with the green
>> signal in
>> + RGB.
>
>
> Are you sure this is what you need for the TVP7002 chip ?
>
Yes

> I think we should differentiate between analog and digital signals and the
> related
> device's configuration. AFAIU for the analog part there can be various video
> sychronisation methods, i.e. ways in which the synchronisation signals are
> transmitted along side the video component (RGB or luma/chroma) signals.
> According
> to [1] (presumably not most reliable source of information) there are
> following
> methods of transmitting sync signals:
>
>  - Separate sync
>  - Composite sync
>  - Sync-on-green (SOG)
>  - Sync-on-luminance
>  - Sync-on-composite
>
> And all these seem to refer to analog video signal.
>
I was about to add all these but as per Laurent mentioned we can add this
whenever there is a need of it.

> From looking at Figure 8 "TVP7002 Application Example" in the TVP7002's
> datasheet
> ([2], p. 52) and your initial TVP7002 patches it looks like what you want is
> to
> specify polarity of the SOGOUT signal, so the processor that receives this
> signal
> can properly interpret it, is it correct ?
>
Yes
> If so then wouldn't it be more appropriate to define e.g. 'sog-active'
> property
> and media bus flags:
>         V4L2_MBUS_SYNC_ON_GREEN_ACTIVE_LOW
>         V4L2_MBUS_SYNC_ON_GREEN_ACTIVE_HIGH
> ?
>
Agreed I'll add these flags.

> And for synchronisation method on the analog part we could perhaps define
> 'component-sync' or similar property that would enumerate all possible
> synchronisation methods. We might as well use separate boolean properties,
> but I'm a bit concerned about the increasing number of properties that need
> to be parsed for each parallel video bus "endpoint".
>
I am not clear on it can please elaborate more on this.

Regards,
--Prabhakar Lad
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/