Re: [RFC 0/2] Delay initializing of large sections of memory

[Nathan Zimmer]

On Fri, Jun 21, 2013 at 01:08:06PM -0700, H. Peter Anvin wrote:
> Is this init code?  32K of unconditional runtime addition isn't completely trivial.

Some of it is init code but not all.
I am guessing 24k of that is actually runtime.

> 
> Nathan Zimmer <nzimmer@xxxxxxx> wrote:
> 
> >On 06/21/2013 12:28 PM, H. Peter Anvin wrote:
> >> On 06/21/2013 10:18 AM, Nathan Zimmer wrote:
> >>>> Since you made it a compile time option, it would be good to know
> >how
> >>>> much code it adds, but otherwise I agree with Greg here... this
> >really
> >>>> shouldn't need to be an option.  It *especially* shouldn't need to
> >be a
> >>>> hand-set runtime option (which looks quite complex, to boot.)
> >>> The patchset as a whole is just over 400 lines so it doesn't add
> >alot.
> >>> If I were to pull the .config option it would probably remove 30
> >lines.
> >> I'm more concerned about bytes of code.
> >Oh, The difference is just under 32k.
> >371843425 Jun 21 14:08 vmlinux.o /* DELAY_MEM_INIT is not set  */
> >371875600 Jun 21 14:36 vmlinux.o /* DELAY_MEM_INIT=y */
> >
> >>
> >>> The command line option is too complex but some of the data I
> >haven't
> >>> found a way to get at runtime yet.
> >> I think that is probably key.
> >>
> >>>> I suspect the cutoff for this should be a lot lower than 8 TB even,
> >more
> >>>> like 128 GB or so.  The only concern is to not set the cutoff so
> >low
> >>>> that we can end up running out of memory or with suboptimal NUMA
> >>>> placement just because of this.
> >>> Even at lower amounts of ram there is an positive impact.I it knocks
> >>> time off
> >>> boot even at as small as a 1TB of ram.
> >> I am not surprised.
> >>
> >> 	-hpa
> >>
> 
> -- 
> Sent from my mobile phone. Please excuse brevity and lack of formatting.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/