RE: [lm-sensors] 3.10: NCT6776F sensor question with Supermicro X9SRL-F motherboard

[Justin Piszcz]

-----Original Message-----
From: Guenter Roeck [mailto:linux@xxxxxxxxxxxx] 
Sent: Wednesday, July 03, 2013 12:33 PM
To: Justin Piszcz
Cc: linux-kernel@xxxxxxxxxxxxxxx; lm-sensors@xxxxxxxxxxxxxx
Subject: Re: [lm-sensors] 3.10: NCT6776F sensor question with Supermicro
X9SRL-F motherboard

[ .. ]
> 
Can you install superiotool and run "sudo superiotool -V -e" ?
I would like to see raw data from the superio chip.

# superiotool -V -e
superiotool r6637
..
Probing for Nuvoton Super I/O (sid=0xfc) at 0x164e...
Found Nuvoton WPCM450 (id=0x1a11, rev=0x00) at 0x164e
Probing for Nuvoton Super I/O at 0x2e...
Found Nuvoton NCT6776F (C) (id=0xc333) at 0x2e

[ .. ]

You have to specify the raw attribute names, not the symbolic ones.
You see the raw attribute names with "sensors -u".

# sensors -u
PCH_CHIP_TEMP:
  temp8_input: 0.000
PCH_CPU_TEMP:
  temp9_input: 0.000
PCH_MCH_TEMP:
  temp10_input: 0.000

Tried:
    ignore PCH_CHIP_TEMP
    ignore temp8_input

For some reason still can't get rid of it appearing:
PCH_CHIP_TEMP:   +0.0 C  
(..as well as the others)


> $ sensors  |tail -n 4
> PCH_CHIP_TEMP:   +0.0 C
> PCH_CPU_TEMP:    +0.0 C
> PCH_MCH_TEMP:    +0.0 C
> 
> Ignoring intrusion works though:
>     ignore intrusion0
>     ignore intrusion1
> 
Does the board have intrusion detection headers ? If so, you could close
(bridge) the header(s) which should get rid of the alarm.

ftp://ftp.supermicro.com/CDR-X9-UP_1.21_for_Intel_X9_UP_platform/MANUALS/X9S
RL-F/X9SRL-F.pdf
@ page 49 (2-23) [motherboard: JL1 2-pin header]

-



--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/