[PATCH] openrisc: Add DTS and defconfig for DE0-Nano
From: Geert Uytterhoeven
Date: Sat Nov 09 2013 - 15:38:08 EST
Add a DTS and defconfig for the Terasic DE0-Nano Development and Education
Board running ORPSoC. This board contains an Altera Cyclone IV FPGA with
support chips and I/O.
The DTS was derived from published versions by Kevin Mehall and Marek
Czerski.
Signed-off-by: Geert Uytterhoeven <geert@xxxxxxxxxxxxxx>
Cc: Kevin Mehall <contact@xxxxxxxxxxxxxxx>
Cc: Marek Czerski <ma.czerski@xxxxxxxxx>
---
Notable changes:
- Change flash0 to spansion,s25sl064p, due to kernel message
m25p80 spi32766.0: found s25sl064p, expected m25p10
- Use reg-shift instead of regstep for i2c0, due to kernel message
ocores-i2c a0000000.ocores: regstep property deprecated, use reg-shift
arch/openrisc/boot/dts/de0_nano.dts | 158 ++++++++++++++++++++++++++++++
arch/openrisc/configs/de0_nano_defconfig | 86 ++++++++++++++++
2 files changed, 244 insertions(+)
create mode 100644 arch/openrisc/boot/dts/de0_nano.dts
create mode 100644 arch/openrisc/configs/de0_nano_defconfig
diff --git a/arch/openrisc/boot/dts/de0_nano.dts b/arch/openrisc/boot/dts/de0_nano.dts
new file mode 100644
index 000000000000..42f91b5184d9
--- /dev/null
+++ b/arch/openrisc/boot/dts/de0_nano.dts
@@ -0,0 +1,158 @@
+/dts-v1/;
+/ {
+ compatible = "opencores,de0_nano";
+ #address-cells = <1>;
+ #size-cells = <1>;
+ interrupt-parent = <&pic>;
+
+ chosen {
+ bootargs = "console=uart,mmio,0x90000000,115200";
+ };
+
+ memory@0 {
+ device_type = "memory";
+ reg = <0x00000000 0x02000000>;
+ };
+
+ cpus {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ cpu@0 {
+ compatible = "opencores,or1200-rtlsvn481";
+ reg = <0>;
+ clock-frequency = <50000000>;
+ };
+ };
+
+ /*
+ * OR1K PIC is built into CPU and accessed via special purpose
+ * registers. It is not addressable and, hence, has no 'reg'
+ * property.
+ */
+ pic: pic {
+ compatible = "opencores,or1k-pic";
+ #interrupt-cells = <1>;
+ interrupt-controller;
+ };
+
+ serial0: serial@90000000 {
+ compatible = "opencores,uart16550-rtlsvn105", "ns16550a";
+ reg = <0x90000000 0x100>;
+ interrupts = <2>;
+ clock-frequency = <50000000>;
+ };
+
+ i2c0: ocores@a0000000 {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ compatible = "opencores,i2c-ocores";
+ reg = <0xa0000000 0x8>;
+ interrupts = <10>;
+ clock-frequency = <50000000>;
+
+ reg-shift = <0>; /* 8 bit registers */
+ reg-io-width = <1>; /* 8 bit read/write */
+
+ adxl34x@1d {
+ compatible = "adxl34x";
+ reg = <0x1d>;
+ interrupts = <26>;
+ };
+ eeprom@50 {
+ compatible = "at24,24c02";
+ reg = <0x50>;
+ pagesize = <8>;
+ };
+ };
+
+ spi0: spi0@b0000000 {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ compatible = "opencores,spi-simple";
+ reg = <0xb0000000 0x5>;
+
+ flash0: mtd@0 {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ compatible = "spansion,s25sl064p";
+ reg = <0>;
+ spi-max-frequency = <40000000>;
+ m25p,fast-read;
+
+ partition@0 {
+ label = "FPGA image";
+ reg = <0x00000000 0x000b0000>;
+ read-only;
+ };
+ partition@b0000 {
+ label = "bootloader";
+ reg = <0x000b0000 0x00050000>;
+ read-only;
+ };
+ partition@100000 {
+ label = "free space";
+ reg = <0x00100000 0x00700000>;
+ };
+ };
+ };
+
+ spi1: spi1@b1000000 {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ compatible = "opencores,spi-simple";
+ reg = <0xb1000000 0x5>;
+
+ adc@0 {
+ compatible = "adcxx,adcxx8s";
+ reg = <0>;
+ spi-max-frequency = <1000000>;
+ };
+ };
+
+ gpio0: gpio@91000000 {
+ compatible = "opencores,jbtrivial";
+ reg = <0x91000000 0x2>;
+ #gpio-cells = <2>;
+ gpio-controller;
+ xlnx,data-offset = <0>;
+ xlnx,tri-offset = <1>;
+ xlnx,gpio-width = <8>;
+ };
+
+ gpio-leds {
+ compatible = "gpio-leds";
+ heartbeat {
+ label = "Heartbeat";
+ gpios = <&gpio0 0 0x0>;
+ linux,default-trigger = "heartbeat";
+ };
+ led1 {
+ label = "led1";
+ gpios = <&gpio0 1 0>;
+ };
+ led2 {
+ label = "led2";
+ gpios = <&gpio0 2 0>;
+ };
+ led3 {
+ label = "led3";
+ gpios = <&gpio0 3 0>;
+ };
+ led4 {
+ label = "led4";
+ gpios = <&gpio0 4 0>;
+ };
+ led5 {
+ label = "led5";
+ gpios = <&gpio0 5 0>;
+ };
+ led6 {
+ label = "led6";
+ gpios = <&gpio0 6 0>;
+ };
+ led7 {
+ label = "led7";
+ gpios = <&gpio0 7 0>;
+ };
+ };
+};
diff --git a/arch/openrisc/configs/de0_nano_defconfig b/arch/openrisc/configs/de0_nano_defconfig
new file mode 100644
index 000000000000..bce8f4862e5e
--- /dev/null
+++ b/arch/openrisc/configs/de0_nano_defconfig
@@ -0,0 +1,86 @@
+CONFIG_CROSS_COMPILE="or32-linux-"
+CONFIG_NO_HZ=y
+CONFIG_LOG_BUF_SHIFT=14
+CONFIG_BLK_DEV_INITRD=y
+CONFIG_INITRAMFS_SOURCE="arch/openrisc/support/initramfs arch/openrisc/support/initramfs.devnodes"
+# CONFIG_RD_GZIP is not set
+CONFIG_EXPERT=y
+# CONFIG_KALLSYMS is not set
+# CONFIG_EPOLL is not set
+# CONFIG_TIMERFD is not set
+# CONFIG_EVENTFD is not set
+# CONFIG_AIO is not set
+# CONFIG_VM_EVENT_COUNTERS is not set
+# CONFIG_COMPAT_BRK is not set
+CONFIG_SLOB=y
+CONFIG_MODULES=y
+# CONFIG_BLOCK is not set
+CONFIG_OPENRISC_BUILTIN_DTB="de0_nano"
+CONFIG_HZ_100=y
+CONFIG_NET=y
+CONFIG_PACKET=y
+CONFIG_UNIX=y
+CONFIG_INET=y
+# CONFIG_INET_XFRM_MODE_TRANSPORT is not set
+# CONFIG_INET_XFRM_MODE_TUNNEL is not set
+# CONFIG_INET_XFRM_MODE_BEET is not set
+# CONFIG_INET_LRO is not set
+# CONFIG_INET_DIAG is not set
+CONFIG_TCP_CONG_ADVANCED=y
+# CONFIG_TCP_CONG_BIC is not set
+# CONFIG_TCP_CONG_CUBIC is not set
+# CONFIG_TCP_CONG_WESTWOOD is not set
+# CONFIG_TCP_CONG_HTCP is not set
+# CONFIG_IPV6 is not set
+# CONFIG_WIRELESS is not set
+CONFIG_DEVTMPFS=y
+CONFIG_DEVTMPFS_MOUNT=y
+# CONFIG_PREVENT_FIRMWARE_BUILD is not set
+# CONFIG_FW_LOADER is not set
+CONFIG_MTD=y
+CONFIG_MTD_M25P80=y
+# CONFIG_M25PXX_USE_FAST_READ is not set
+CONFIG_PROC_DEVICETREE=y
+CONFIG_EEPROM_AT24=y
+CONFIG_NETDEVICES=y
+# CONFIG_ETHERNET is not set
+# CONFIG_WLAN is not set
+# CONFIG_INPUT_MOUSEDEV is not set
+# CONFIG_INPUT_KEYBOARD is not set
+# CONFIG_INPUT_MOUSE is not set
+CONFIG_INPUT_MISC=y
+CONFIG_INPUT_ADXL34X=y
+# CONFIG_INPUT_ADXL34X_SPI is not set
+# CONFIG_SERIO is not set
+# CONFIG_VT is not set
+# CONFIG_LEGACY_PTYS is not set
+# CONFIG_DEVKMEM is not set
+CONFIG_SERIAL_8250=y
+CONFIG_SERIAL_8250_CONSOLE=y
+CONFIG_SERIAL_OF_PLATFORM=y
+# CONFIG_HW_RANDOM is not set
+CONFIG_I2C=y
+# CONFIG_I2C_COMPAT is not set
+CONFIG_I2C_CHARDEV=y
+CONFIG_I2C_OCORES=y
+CONFIG_SPI=y
+CONFIG_SPI_OCSIMPLE=y
+CONFIG_GPIO_JBTRIVIAL=y
+CONFIG_SENSORS_ADCXX=y
+# CONFIG_HID is not set
+# CONFIG_USB_SUPPORT is not set
+CONFIG_NEW_LEDS=y
+CONFIG_LEDS_CLASS=y
+CONFIG_LEDS_GPIO=y
+CONFIG_LEDS_TRIGGERS=y
+CONFIG_LEDS_TRIGGER_TIMER=y
+CONFIG_LEDS_TRIGGER_ONESHOT=y
+CONFIG_LEDS_TRIGGER_HEARTBEAT=y
+CONFIG_LEDS_TRIGGER_GPIO=y
+CONFIG_LEDS_TRIGGER_DEFAULT_ON=y
+CONFIG_LEDS_TRIGGER_TRANSIENT=y
+# CONFIG_DNOTIFY is not set
+CONFIG_TMPFS=y
+CONFIG_NFS_FS=y
+# CONFIG_ENABLE_WARN_DEPRECATED is not set
+# CONFIG_ENABLE_MUST_CHECK is not set
--
1.7.9.5
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/