Re: [PATCH] cpufreq: cpufreq-cpu0: Use a sane boot frequency whenbooting with a mismatched bootloader configuration

[Nishanth Menon]

On 11/18/2013 09:46 PM, Viresh Kumar wrote:
> On 19 November 2013 07:51, Shawn Guo <shawn.guo@xxxxxxxxxx> wrote:
>> No, I did not say that.  IMO, when cpufreq-cpu0 sees a mismatch, it has
>> no way to know or assume which one is correct and which is incorrect.
>> The best thing it can do is to fail out without changing anything about
>> running frequency and voltage.
> 
> Not specifically on this patch, but this is what I feel about this issue:
> 
> - As we are discussing on the other thread, there is scope of adding
> "unknown" field in tables so that people would know that they were
> running out of table freq at some point..

Consider something like userspace governor selection -> the device at
boot will probably remain in an unknown/"invalid" configuration till
the very first transition attempt. I am less worried about the stats
than not following what the hardware description is (as stated by
device tree/other forms).

I staunchly disagree that at a point of mismatch detection, we just
refuse to load up cpufreq governor -even though we know from device
tree/other alternative entries what the hardware behavior is supposed
to be. To refuse to loadup to a known configuration is considering the
"valid configuration" data provided to the driver is wrong - an
equivalent(considering the i2c example) is that if i2c driver sees bus
configured for 3.4MHz and was asked to use 100KHz, it just refuses to
load up!

> - This is a common problem for all drivers/platforms and not only
> cpufreq-cpu0, so the solution has to be generic and not driver
> specific.. So, atleast I don't want to get this patch in at any cost,
> unless there is a generic solution present..
> - There are non-dt drivers as well, and so freq table is present
> with the kernel and we can't support all frequencies that bootloader
> may end up with..
The above two are fair comments -> but that implies that policy->cur
population should no longer be the responsibility of cpufreq drivers
and be the responsibility of cpufreq core. are we stating we want to
move that to cpufreq core?

-- 
Regards,
Nishanth Menon
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/